Electrically operated roof sheet, type "Cramaro"
Operation takes place using a control panel on the side of the trailer (see Figure 7.4.2.b.).
Remove the tensioning cables of the roof sheet to the rear and side of the trailer.
Insert the key in the middle of the emergency stop (the emergency stop is on the side of the
control panel).
Open the control panel door
The roof sheet can be opened or closed with the selector switch (3) (see Figure 7.4.2.c.). The
indicator light (2) is on while roof sheet is moving.
If an obstacle is encountered when opening or closing the roof sheet the safety fuse (1) will
activate and the movement of the roof sheet will stop. Remove the obstacle, reset the safety fuse
and try to open or close the roof sheet again with the selector switch (3).
If a problem occurs the emergency stop can be pressed. This is reset with the key.
When the roof sheet is fully open or closed, close the control panel door, remove the key and
press the emergency stop. This prevents unauthorised use.
When the roof sheet is closed, fix the tensioning cables to the anchor points on the side and rear
end of the trailer.
Figure 7.4.2.b. – Electrically operated roof sheet, type "Cramaro"
Figure 7.4.2.c. – Operating panel, electrically operated roof sheet, type "Cramaro"
STAS nv – Flanders Fieldweg 45 – 8790 WAREGEM (BELGIUM)
Tel. +32 (56) / 60 01 91 – Fax +32 (56) / 60 01 95 – e-mail : sales@stas.be web –- http://www.stas.be
8.
Tipper accessories
8 . 1 .
T ow i n g h o o k
Figure 8.1.a. – Towing hook
The towing hook is fitted at the back of the trailer.
Only use the towing hook for towing another vehicle. The towing hook must
not be used to pull out stuck vehicles (excessive load).
Instructions for use, tipper trailer – Version 3.1
Page 36
Need help?
Do you have a question about the STAS Bs and is the answer not in the manual?
Questions and answers