Panel Reset; Factory Default Restore - Visonic PowerMaster 360 Installer's Manual

Deleting a Z-Wave Device
To delete an enrolled device, proceed as follows.
1. Press and hold the (-) button ("J" in Figure 3.1) for 2 seconds. The red LED ("N" in Figure 3.1) blinks quickly and a
happy beep is heard and then the LED turns off.
Notes:
1. To abort the procedure during this stage, press and hold the (+) or (-) buttons for 2 seconds. The LED will stop
blinking.
2. If the procedure fails, the red LED lights constantly for 3 seconds and a sad beep is heard.
3. Long press on the (-) button, returns the panel to normal operation

3.8 Panel Reset

To reset the panel, use a blunt instrument to press the Reset button ("K" in Figure 3.1), or, alternatively, exit the
Installer Mode. The Orange LED ("N" in Figure 3.1) lights constantly until Panel initialization is completed and the
PowerLink is reset. Finally, the Orange LED ("N") turns off.

3.9 Factory Default Restore

This procedure is performed to restore system parameters to factory default parameters. Back to Factory can be
performed only when the panel is in the Disarmed state.
1. Press the Back to Factory button ("L" in Figure 3.1) for 30 seconds.
Note: During Back to Factory, the red LED ("N" in Figure 3.1) blinks.
2. If Back to Factory is successful: the green LED blinks 3 times and a happy beep is heard and then the panel
immediately initiates software reset.
Note: If the Back to Factory procedure fails, the red LED lights constantly for 3 seconds and a sad beep is heard.
D-305735 PowerMaster 360 Installer's Guide
3. INSTALLATION
11