Tennant T3 Use And Care Manual

FOR SAFETY: DO NOT operate machine unless operator manual is read and understood.
BEFORE EACH USE
1. Sweep floor before
scrubbing.
6. FaST Model - Check
FaST- PAK level. Replace
PAK as needed.
AFTER EACH USE
1. Drain and clean out
recovery tank.
6. Clean squeegee
blades.
MONTHLY:
1. Clean batteries. Use
a strong mixture of
baking soda and water.
ATTENTION: FOR MACHINE REPAIRS, CONTACT AN AUTHORIZED SERVICE CENTER.
9001525 Rev 01 (06- 05)
USE and CARE Guide
2. Check battery
meter charge level.
Recharge if needed.
7. FaST Model - Check
FaST- PAK supply hose
for proper connection.
2. Remove and rinse
off recovery tank screen.
7. Clean machine with
an all purpose cleaner
and damp cloth.
Refer to Operator's Manual for further details.
2. Check for loose
battery cable
connections.
3. Check scrubbing
brush or pad. Replace if
worn.
8. Check scrub head
skirt for damage.
3. Drain and rinse out
solution tank.
8. FaST Model -
Connect FaST- PAK
supply hose to storage
plug when not in use.
3. Lubricate all pivot
points and rollers with a
water resistant grease.
4. Check squeegee
blade wiping edge.
Rotate blade if worn.
9. For Conventional
Scrubbing Only - Fill
solution tank with water
(140° max.) and add
4. Remove and clean
the solution tank filter.
9. Recharge batteries if
machine was used 30
minutes or more. Check
battery fluid level before
4. Clean and inspect
recovery tank seal.
Replace if damaged.
5. Make sure recovery
tank is empty and screen
is clean.
approved cleaning
agents.
FaST Model - USE CLEAR
COOL WATER ONLY. DO
NOT add cleaning agents
into the solution tank,
FaST solution system
failure may result.
5. Remove and clean
pad or brush.
charging. Fluid level
should cover battery
plates by 1/4". DO NOT
OVERFILL.
Wet/Lead Acid Batteries
ANNUALLY:
FaST Model -
Clean or replace the
injector orifice plate and
filter screen.
www.tennantco.com