Installation; Operating Environment; Power Supply; Power Specifications - Sony MVS-6530 Installation Manual

1-1. Operating Environment

Operating guaranteed temperature:
Performance guaranteed temperature: +10 dC to +35 dC
Operating humidity (relative humidity): 10 % to 90 %
Storage temperature:
Mass (when options are installed) :
MVS-6520: Approx. 20 kg
MVS-6530: Approx. 21 kg
MVS-3000: Approx. 19 kg
Prohibited locations for installation
. Areas where the unit will be exposed do direct sunlight
or any other strong lights.
. Dusty areas
. Areas subject to vibration.
. Areas with strong electric or magnetic fields.
. Areas near heat sources.
. Areas subject to electrical noise.
. Areas subject where is subjected to static electricity.
Ventilation
In this unit, the air cooling is performed by using the fan
motor 120 square (for plug-in board) and fan motor (for
power unit).
(Refer to the air flow illustration of "Fan" in Section
2-2-2.)
The power supply can be damaged if the exhaust vent (both
sides) and air intake (front panel) are blocked or the fan is
stopped.
Therefore, leave a blank space of more than 10 cm in the
front and both sides of the MVS-6520/6530/3000.

1-2. Power Supply

1-2-1. Power Specifications

A switching regulator is used for the power supply of this
unit. The voltage within the range of 100 V to 240 V can be
used without changing the supply voltage.
AC 100 to 240 V ?10 %
Power requirements:
Power frequency: 50/60 Hz
Current consumption (when all options are installed) :
MVS-6520/6530/3000: 4.0 to 1.7 A
MVS-6520
Section 1

Installation

m
. As the inrush current at turn-on is a maximum 100 A (at
+5 dC to +40 dC
100 V)/175 A (at 230 V), the capacity of the AC power
source must be commensurate with this load.
If the capacity of the AC power is not adequately large,
_20 dC to +60 dC
the AC power source breaker will operate or the unit will
abnormally operate.
. The MVS-6520/6530/3000 contains two power supply
units as the standard configuration. When starting up the
MVS-6520/6530/3000, be sure to turn on the power of
two power supply units.

1-2-2. Power Cord

w
. Use the approved Power Cord (3-core mains lead)/Appli-
ance Connector/Plug with earthing-contacts that con-
forms to the safety regulations of each country if appli-
cable.
. Use the Power Cord (3-core mains lead)/Appliance
Connector/Plug conforming to the proper ratings (Volt-
age, Ampere).
If you have questions on the use of the above Power Cord/
Appliance Connector/Plug, please contact your local Sony
Sales Office/Service Center.
c
. Never use an injured power cord.
. Plugging the power cord in the AC inlet, push as far as it
will go.
For customers in the U.S.A. and Canada
For customers in the all European countries
1 Power cord, 125 V 10 A (2.4 m) : ! 1-551-812-31
1
1 Power cord, 250 V 10 A (2.5 m) : ! 1-782-929-12
1
AC inlet
AC inlet
1-1 (E)