If there is anything missing or damaged, please preserve serial no., shipping carton and call the dealer from whom you purchased for assistance. Model Galaxy 330 Galaxy 330 Software (Optional) Galaxy 330 Colony Counter PC Software USB flash drive Magnifier...
Notice of Operation To avoid the instrument from being burnt or disordered on operation, please use 12V DC power adaptor and USB connecting cable supplied by manufacturer for operation. Don’t scratch the surface of Petri dish holder to avoid affecting the illumination of backlight. Please discard packing material according to related regulations.
Page 5
Assembly Item Description Galaxy 330 Colony counter Magnifier Magnifier holder USB connecting cable (Optional) AC/DC switching adaptor Screwdriver Marking pen (Black) PC Software USB flash drive (Optional)
Page 6
Main Part Diagram Item Description Item Description Power socket Petri dish holder (60mm) Adjustable Petri dish holder Power switch (90~150mm) Control panel Background plate Magnifier holder Pressure sensitivity regulator Adjustable screw Acoustic counting signal regulator Magnifier Light intensity regulator Petri dish position USB connecting port...
Introduction of Control Panel Item Description Counted value display (LED-A) Storage value display (LED-B) Storage value display (LED-C) Storage value display (LED-D) Save/Next Average / Previous Back / Exit Delete USB Connecting indicator (Green: connecting / Red: off)
Installation Item Description Magnifier position Magnifier holder Adjustable screw Magnifier Plug the power cord into the main unit and make sure the supplied voltage is within affordable range of power adaptor. Install the magnifier on the main unit by following above diagram and adjust the height of magnifier properly.
Operation Key and Signal (1) Normal Mode︰ SAVE Store the count in the memory Average saved counts AVERAGE <display value on (LED-A) > Decrease the value on (LED-A) BACK ( alarm with a bleep ) Delete the count DELETE < alarm with long bleep> (2) View Mode︰...
Page 10
Operation under Normal Mode Place the Petri dish (1) on the dish holder and slide the adjuster (2) properly. Attention: For the Petri dish with 60mm in diameter, you can use “Petri dish holder (60mm)” to fix the Petri dish. Ensure the display on LED-A is "000"...
Page 11
After counting, press the “SAVE” key, the saved count will be displayed on LED-B. Place the next Petri dish and press <SAVE > key to resume the count. Repeat until all dishes have been counted. The saved counts will display on LED-B, LED-C, LED-D in order.
Page 12
Notice: (1) If the counted Petri dishes are over 3 batches, the display will only show the record of latest 3 batches. For the record of previous counts, it will be saved, but not show on display. The main unit can store up to 100 records in memory. It will fail to work if the record is over 100.
Press the “NEXT” key to check the next record. It will alarm with a bleep when it goes to the last record. Press the “PREVIOUS” key to check the previous record. It will alarm with a bleep when it goes to the first record.
Troubleshooting Symptoms Possible causes and Solution 1.Check the power supply conform to power specified (DC12V) on main unit Device fails to start 2.Check if the power switch is in the ON position 3.Malfunction of internal parts or internal tubing are loose contact your distributor for repair 1.
Need help?
Do you have a question about the Galaxy 330 and is the answer not in the manual?
Questions and answers