PAT America DS 350 Service Manual page 25

Load Reading
Check power supply to force transducer by unplugging the cable assembly from the force transducer.
Measure voltage at the cable connection between A (+12/24v) and C (ground) at the connector.
!
Correct?
NO
!
!
Complete the force transducer calibration in operator's and calibration manual. If force
© PAT
Rev. - 12/18/00 // CSH.
PREVIOUS PAGE
Refer to Drawing 1 in Section 12.
Check linerider for any visual damages and check continuity in:
force transducer cable assembly (A to A, B to C, C to B, note the wiring of the
connector)
junction box (5 socket to 14 pin: A to D, B to C, and C to A)
cable reel, and cable assembly 14 pass connectors B to B, C to C, and D to D.
YES
Check force transducer for any visual damages.
transducer can not be adjusted replace force transducer.
Refer to Procedure 5 and Drawing 1 or 7.
Refer to Drawing 1.
No Fault in cable or wiring.
END
19
190118_-.DOC