JET Performance Products V-FORCE Plus Installation & User Manual page 4

OPERATING THE V-FORCE PLUS
Reconnect the negative battery cable that you removed during the first part
of the installation.
1. The Power Button (PWR) will turn the unit ON / OFF. When Power-
ing the V-Force Plus for the first time, the display will show the
Jet Logo then display the version number of the current software.
The V-Force Plus can be left ON from this point. The unit will
go into StandBy mode when the vehicle is turned off and will come out
of StandBy mode when the vehicle is restarted. After the first power
up the V-Force / PCU Plus will automatically revert back to the last
screen used the next time you start the vehicle.
2. The Arrow Buttons allow the user to scroll forward or back through
the screens.
3. The DIM button adjust the Brightness of the display, by repeatedly
pressing the DIM button the Brightness will continue to increase.
4. Pushing the DIM button and then using the arrow keys, you can control
the contrast of the display.
The V-Force has fourteen different screens to chose from. These screens
allow the user to monitor the following vehicle sensors. Manifold Absolute Pressure /
Mass Air Flow; Throttle Position; Battery Voltage; Fuel Economy; Air / Fuel mixture
ratio ( Please see OPTIONAL for O2 sensor connection ). The display makes use of
three different types of display. A Bar Graph, Line Graph and Data Display.
NOTE:
Some vehicles that connect to the MAF Sensor may not get ac-
curate readings or may not receive any readings at all on the MAP/MAF or
Fuel Economy screens.
SCREENS
-3-