Summary of Contents for Scale Mellanox SN2010
- Page 1 Mellanox SN2010 Quickstart Guide Document Version 1.0: 10/2018 1 © Scale Computing 2018...
-
Page 2: Table Of Contents
Configure Spanning Tree 9 Generate Troubleshooting Diagnostics 11 Feedback & Support 12 Document Feedback 12 Technical Support and Resources 12 Disclaimer 12 2 © Scale Computing 2018... -
Page 3: Introduction
The SN2010 supports the same features and scale as the SN2700. The SN2010 design allows either stand-alone single switch installation, or side-by-side placement of two switches in a single 1RU slot of a 19” rack, delivering high ... -
Page 4: Connect To The Switch
● Data bits = 8 ● Flow control = none The default username is a dmin and the default password is a dmin . 4 © Scale Computing 2018... -
Page 5: Cli Mode Basics
(config)# Configuration of switch ports is performed in interface configuration mode. To return to the previous configuration level: (config interface ethernet 1/1)# exit (config)# 5 © Scale Computing 2018... -
Page 6: Initial Configuration
Zero-touch is disabled Configuration changes saved. To return to the wizard from the CLI, enter the " configuration jump-start" command from configure mode. Launching CLI... switch-2f5160 [standalone: master] > 6 © Scale Computing 2018... -
Page 7: Update The Firmware
To examine what firmware images are currently loaded on the system: (config)# show images Reboot the switch to load the new firmware: (config)# reload 7 © Scale Computing 2018... -
Page 8: General Configuration
Troubleshooting relies heavily on inspecting the switch events. To enable event tracking for the group i nterfaces : logging events (config)# i nterfaces enable If there is a remote syslog server available: (config)# logging 10.205.13.36 8 © Scale Computing 2018... -
Page 9: Port Configuration
Switchport Hybrid Mode Hybrid mode is used when an interface needs to carry multiple VLANs, such as the Scale Computing LAN ports. If your VMs need access to specific VLANs other than what the Scale Computing node itself resides upon, you will ... - Page 10 Max Age (sec) : 20 Forward Delay (sec): 15 L: Loop Inconsistent R: Root Inconsistent G: BPDU Guard Inconsistent -------------------------------------------------------------------------- Interface Role Cost Prio Type -------------------------------------------------------------------------- 10 © Scale Computing 2018...
-
Page 11: Generate Troubleshooting Diagnostics
Replace the user r oot and the p assword with your user credentials. Replace the path / root to one appropriate for your local machine. 11 © Scale Computing 2018... -
Page 12: Feedback & Support
Disclaimer Switches are not covered under the support and warranty for the Scale Computing HC3 system. Scale Computing is not responsible for any issues arising from the use of this guide. Any and all questions, issues, or concerns regarding switch configuration should be addressed with the switch manufacturer directly. ...
Need help?
Do you have a question about the Mellanox SN2010 and is the answer not in the manual?
Questions and answers