Operation; Maintenance - Makita 6821 Instruction Manual

Installing or removing the bit
Pull the locator out of the locking sleeve while turning the
locator slightly. Then grasp the bit with a pair of pliers
and pull the bit out of the magnetic bit holder. Sometimes,
it helps to wiggle the bit with the pliers as you pull.
1
2
002652
To install the bit, push the bit firmly into the magnetic bit
holder. Then install the locator by pushing it firmly onto
the locking sleeve while turning the locator slightly.
1
2
002660

OPERATION

002672
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
When fitting the screw onto the point of the bit, be
•
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
1. Locator
2. Locking sleeve
1. Bit
2. Magnetic bit
holder
5
Make sure that the bit is inserted straight in the
•
screw head, or the screw and/or bit may be
damaged.
Do not continue unnecessary clutching operation.
•

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Insert bits
•
Magnetic bit holder
•
or attachments
Only use accessory or
are