Initial Setup Without A Computer - Mobotix T25 System Manual

24
/128
Access Module
KeypadRFID
Access Module
BellRFID with bell
button set F2
T25 System Manual Part 2: Initial Setup without a Computer
2

INITIAL SETUP WITHOUT A COMPUTER

We recommend reading Chapter 2 carefully before starting with the initial setup in Section 2.1
to avoid operating errors. Please first read this selection of frequently asked questions:
How Do I Initiate the Initial Setup Process without a Computer?
With the exception of the special case described in Section 1.3.3, «Network without DHCP
Server (Static IP Addresses)» , the initial setup always starts with the Auto Configuration
process, which is activated by pressing the bell button on the camera module. This
procedure is described in Section 2.1, «Step 1: Perform the Auto Configuration» and ends
with a short functional test.
What Do I Need to Do After Auto Configuration?
If the door station has a KeypadRFID module , all you need to do now is to enter an 8 to
16-digit Super PIN of your choice and train the red (admin) transponder card (see
Section 2.2, «Step 2: Set Up the KeypadRFID Access Module» ). You can also easily set up
the blue user cards; however, it is not absolutely necessary to do this now.
If the door station has a BellRFID module , you can now enter an 8 to 16-digit Super PIN
of your choice and train the supplied red admin card (see Section 2.3, «Step 2: Set Up
the BellRFID Access Module» ). In this case, you can also easily set up the blue user cards;
however, it is not absolutely necessary to do this now.
As the owner of a door station with an access module (KeypadRFID or BellRFID), you are
free to choose how many of the supplied user cards you would like to train (i.e., to set
up). Once you have trained a card, you can use it for keyless entry at that door (using
passive RFID technology, no battery required) and listen to messages recorded in your
voice mailbox on the outdoor station.
If you like, you can also use custom Personal, Transponder and Contact Numbers to
personalize the cards. For further details and information on how to manage all your
access media (cards and PINs), please refer to the documentation for the installed access
module ( Chapter 3, «KeypadRFID Access Configuration» or Chapter 4, «BellRFID Access
Configuration» , respectively).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Start Auto Configuration
www.mobotix.com • sales@mobotix.com