Samsung Owner's Owner's Manual page 9

4. Turn on "HOT" and "COLD "water supply
and check all connections at the water
valve and the faucet for leaks.
5. Plug power cord into a 3-Prong, well grounded 120 volt 60 Hz
approved electrical outlet protected by a 15-amp fuse or comparable
circuit breaker.
Your Washer is grounded through the third prong of the power cord
when plugged into a three-prong grounded receptacle.
6. Slide your Washer into position.
7. Level your Washer by turning the
leveling legs in or out as necessary by
hand or wrench included with your
Washer.
When your Washer is level, tighten the
nuts using the wrench or (-)driver.
NOTE: Your Washer must be leveled
on all four sides. A carpenter's
level should be used on all
four corners of your Washer. It's a good idea after the first dozen washes to recheck your
Washer's levelness.
8. Before installing the rubber-cup, attach the tape provided to the base of the rubber-cup.
9. If you install your washer on softfloor, you should place the rubber cup under adjustable leg. Before
put rubber cup, please remove film for double-side tape attached on rubber cup.
NOTE: If washer is installed on riser,
you should put rubber cup
under leg for riser.
Installing Your Washer
SAMSUNG Clothes Washer Owner's Instructions A-5