Thank You! for purchasing your new S&B Filters intake kit. If at any time you need additional assistance with installation or have any other questions or comments, feel free to call our customer service department at 909-947-0015. You can also take advantage of our live chat at www.sbfilters.com and connect with an S&B representative immediately.
GENERAL INFORMATION AND WARNINGS Operation in snow and rain If you are driving in heavy snowfall or extreme rain conditions, you should always check for accumulated snow and water on the air filter following your OE recommendations for driving in these conditions. The following is recommended after operating the vehicle up to 100 miles in heavy snowfall or extreme rain: At the earliest opportunity, open the hood and check the air box and filter.
INSTALLATION STEPS: With the ignition switched off and the parking brake set, Lift and pull to remove the engine cover from the vehicle. disconnect the negative battery cable on the driver side. Note: Failure to disconnect the battery may cause the CEL to illuminate upon completion of the installation and subsequent operation.
Page 7
Remove the bolt securing the resonator and loosen the clamp at the throttle body. Unlatch the clips securing the lid to the airbox then remove the lid, resonator and intake tube from the vehicle. Tool Required: 10mm Socket/Wrench Remove the stock air filter from the stock air box.. Loosen and remove the three bolts securing the base of the airbox to the vehicle then remove the airbox.
Page 8
INSTALLATION STEPS: Unscrew the bolt securing the resonator bracket to the Remove the grommets and support bushings from the vehicle and remove the bracket. stock airbox. Tool Required: 10mm Socket/Wrench ...continued from Step 10a. Install the grommets and support bushings onto the Airbox (A).
Page 9
Determine if you want to install the Box Plug onto the Airbox Place the Airbox in the engine bay. Make sure you line up the fender seal with the fender opening, the three mounting or leave it open. See the “Air Box Plug” note on Page 2 for grommets are lined up with the mounting points, and the two more information.
Page 10
INSTALLATION STEPS: Install the Coupler onto the Intake Tube so it is flush Insert the Intake Tube into the Airbox (A). with the end of the intake tube. Slide the Coupler over the throttle body then tighten both #52 Remove the stock hose clamp from the CCV hose and Hose Clamp (Q).
Page 11
Attach the Air Filter with #84 Hose Clamps to the Install the Lid Seal onto the Airbox Intake Tube (B). Tighten the hose clamp to secure the air filter to the intake tube. Tool Required: 8mm Socket/Wrench Peel off the protective covering on the Clear Lid (I). Install the Clear Lid using the provided Washers Screws (L).
Page 12
INSTALLATION STEPS: Reconnect the negative battery cable. Inspect your installation, make sure the kit is properly positioned and all fasteners are secure. Keep all stock parts incase you would ever need to reinstall the stock intake assembly. Affix the ID label near the intake kit. The installation is now complete.
RELATED ITEMS FOR YOUR PURCHASE Order Online today at www.sbfilters.com or through your local S&B distributor. Replacement Replacement Filter Wrap Precision II: Cotton Filter Dry Filter for KF-1035 Cleaning & Oil Kit SKU# KF-1035 SKU# KF-1035D SKU# WF-1023 SKU# 88-0008 INSTALLATION NOTES: SBFILTERS.COM...
Need help?
Do you have a question about the 75-5115 and is the answer not in the manual?
Questions and answers