Front View (Without Front Bezel) - NEC Express5800 Series User Manual

Chapter 1 General Description
4.2

Front View (Without Front Bezel)

(8)-0
(8)-1
(10) (9)
(9)
See (3) to (5) on previous page.
(8) 2.5-inch Hard Disk Drive Bay
Bays for installing HDDS. The sequential numbers indicate
the corresponding slot numbers. All bays include Dummy
Trays as standard.
(9) DISK Access LED
LEDs for showing the access of hard disk drives.
The LED is provided for each hard disk drive.
(See page 36)
(10) DISK STATUS LED
LEDs for showing the status of hard disk drive.
The LED is provided for each hard disk drive.
(See page 36)
(11) POWER Switch/LED
A switch for turning on/off the server. Press once to turn on
the server. POWER LED lights when it is on. Press it again
to turn off the server. Hold down the switch for four seconds
or more to forcibly turn off the server.
(See page 33)
(12) Unit ID (UID) Switch/LED
A switch for turning on/off UID LED.
Pressing the switch once turns on UID LED and pressing
again turns off the LED.
Commands from the software also cause it to turn on or
flash.
(See page 35)
(13) RESET Switch
A switch for resetting the server.
(14) DUMP Switch (NMI)
A switch for collecting the memory dump.
26
(8)-2 (8)-4
(8)-3
(8)-5
(9)
(9)
(10) (10)
Express5800/R120f-1E User's Guide
(16)-1 (16)-2
(11)
(14)
(17)
(15)
(12)
(18)
(13)
(10)
(9) (10)
(8)-7
(8)-6
(22)
(15) BMC RESET Switch
A switch for resetting BMC of this server. Use the switch
only when there is a problem with EXPRESSSCOPE
Engine 3 (BMC).
To use this switch, press it at least five seconds.
(16) STATUS LED 1, 2
LEDs for showing the server status.
(See page 33)
(17) Power Capping LED
An LED for showing the power capping status of the server.
(See page 35)
(18) LINK/ACT LED
LEDs for showing the access status of LAN.
(3)-1: LAN1 connector
(3)-2: LAN2 connector
(3)-3: LAN3 connector
(3)-4: LAN4 connector
LEDs for LAN3 and LAN4 are lit when optional LOM card
(N8104-154/156) is installed.
(19) USB Connectors (front)
Connectors for connecting USB interface devices.
(20) Pull-out Tab
A tab for showing the part number and serial number of the
server.
(21) Display Connector
A connector for connecting a display. This connector
cannot be used with the display connector on rear panel at
the same time.
(22) Optical Disk Drive Bay
A bay for installing an optical disk drive.
Either of the following drive can be installed.
– DVD-ROM drive
– DVD SuperMULTI drive
4. Names and Functions of Parts
(19)
(20)
(21)