Wiegand Input Connections - PTI security systems Falcon XT Installation Manual

Wiegand Input Connections

There are two Wiegand device inputs on the controller circuit board. These can be connected to
most Wiegand output devices, such as proximity card readers, remote door openers, etc. Refer
to the software Help Files for more information on setting up Wiegand inputs.
The two Wiegand inputs are commonly used to control a proximity reader to the office entrance
where the controller is located, or to control a proximity card reader that allows the proximity
cards to be registered and assigned without going out to an AI device on the property.
There are generally 8 – 10 color-coded wires that connect to a Wiegand input device. These are
connected to the controller circuit board as necessary. Refer to the manufacturer's instructions
for the Wiegand device to get wire color coding and connection assignments.
+12V
+5V
Grnd/Shld
Data 0
Data 1
Green LED
Red LED
Beeper
Hold
Tamper/CP
28
Connection point for the + wire on 12VDC Wiegand devices
Connection point for the + wire on 5VDC Wiegand devices
Connection point for – DC wire and for the Data Ground wire
Connection point for the Data 0 input wire
Connection point for the Data 1 input wire
Connection for the optional Green LED entrance light wire
Connection for the optional Red LED access denial light wire
Connection for the optional beep on entrance function wire
Connection for the optional hold function wire
Connection for the optional Card Presence and/or Anti-
tamper wire
114A3866.C.05 Revised 7-2017