Topeak ALiEN III User Manual

A
LiEN
Disc Brake
Pad Spacer
Tire Lever
Phillips
T25
Torx
3mm
6mm/
4mm
10mm
2-L mm
5mm
Mavic M7
Chain Pin
2.5mm
8mm 10mm 6mm 5mm 4mm 3mm
9mm
T25 10mm
14g Shimano 15g
III
™
The ultimate tool for road and mountain biking
Chain Hook/
8mm
Universal
Chain Tool
Stainless Knife
Congratulations on your purchase of Topeak's ALiEN III tool. It's the
first two-piece mini tool designed for both road and mountain cyclists.
10mm The ALiEN III tool folds neatly for easy storage and carrying. Each
9mm
Mavic M7
14g
8mm
Shimano
15g
Flat
Clip bag
Tool Screwdriver
included
1. Depress the locking button with your thumb.
2. Slide the sections apart.
Locking
Button
2.5mm 2-Lmm
The knife blade on the ALiEN III is sharp.
Be careful when using the knife blade. Use extreme
caution when opening and closing your ALiEN III tool.
8mm
Mavic M7
WARNING
Using Locking Lever on B section
WARNING
tool is designed for maximum durability
and strength for years of trouble-free use.
This guide will instruct you in the proper use
of your ALiEN III tool.
Please read all instructions and warnings carefully
before using the ALiEN III tool.
Separating two sections
B section
A section
The B section contains a very sharp knife blade. Be careful
when using the knife blade. Make sure the knife blade is
locked securely in the open position when used. Failure to
lock knife blade during use can result in serious injury. Be
careful when storing knife blade. Make sure all fingers are
clear of blade path. Be sure knife blade is locked closed
during storage to prevent accidental deployment.
User's Guide
The locking llever is used to lock tools in place during use, and to
keep tools from deploying when stored. For additional safety, the
locking lever is also used for knife blade storage.
Locking Lever
Using the T25 Torx Wrench Using the Disc Brake Pad Spacer
Tighten disc brake rotor bolts Fit a disc brake pad SPACER in each
with the T25 Torx wrench. caliper when transporting with
unmounted front and /or rear wheel(s)
with hydraulic disc brakes.
Using the 6mm and 10mm Allen Keys
The 6mm and 10mm Allen keys are combined.
Remove the 10mm Allen head to use the 6mm
Allen key.
Add the 10mm Allen head to use on crank bolts.
GB
Prepare to Ride