hager 2942 Installation Instructions Manual

Quick Mount
Interlocking
Mounting Assembly
Mounting Screws
Electrical Instructions:
Use properly fused U. L. Listed Power Supply
Do not install a diode in parallel with any magnetic lock. A diode
will cause a delay when releasing the door and residual magnetism
to occur.
Although Hager recommends the use of a DC power supply, a
transformer with an adjacent mounted full wave bridge rectifier
may be used. A significant drop will occur when using a full wave
bridge rectifier.
Any low voltage condition will cause erratic operation of the
optional board sensor.
When using a full wave bridge rectifier all access controls and/or
release contacts must be located between the Magnetic Lock and
rectifier to ensure quick release.
Rev 2, Rev Date: 8/15/18
INSTALLATION INSTRUCTIONS
2942 MAGNETIC LOCK
Interlocking
Mounting Plate
Armature
Always visit www.hagerco.com for the latest Installation Instructions
HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 • (800) 325-9995
Frame
Electrical Specifications:
Dual Voltage
Power Consumption
DS Door Status Sensor SPDT, 500mA@30VDC
LS Lock Status Sensor SPDT, 2A@30VDC
2942 Magnetic Lock
Installation Instructions
I-EA00054
Outswing
12 or 24VDC
500mA@12VDC
250mA@24VDC
Page 1 of 4