Download Print this page
Zoo Med REPTITEMP 500R Installation Instructions

Zoo Med REPTITEMP 500R Installation Instructions

Remote sensor thermostat

Advertisement

Quick Links

Day/Night Cycle Feature, continued
Note: Make sure that the
lower
wattage
nighttime heating device has enough
watts so your terrarium does not drop
more than 10°F at night. Use Zoo
Med's
Min/Max
Thermometer to
monitor both the day and night
temperatures.
When the timer turns back on in the
morning, the thermostat will then
automatically re-establish the "daytime"
temperature set point.
Lastly, make sure that your lower
wattage nighttime heat source is a
non-
illuminating
Ceramic Heat Emitter, Repti
Infrared Heat Lamp or Under Tank
Heater and
not
an
illuminating
type heat
bulb as your animals need natural
darkness at night.
WARRANTY
Zoo Med Laboratories, Inc. (Zoo Med)
warrants each ReptiTemp® Thermostat
Temperature Control product to be free
of defects in material and workmanship
under normal use and service for
12
calendar months.
The obligation under
this warranty is limited to the
repair or
replacement,
at Zoo Med's election, of the
product or any part thereof, when the
returned to Zoo Med,
product is
freight
prepaid. No claim shall be allowed
under this warranty if, in the opinion of
Zoo Med, the thermostat or part has
been subject to accident or improper
usage, including but not limited to: water
damage, improper storage, accidental
dropping, etc. This warranty is in lieu of
all other warranties and representations,
express or implied. Please include your
receipt, full name, address, and phone
number along with a note explaining
failure when sending any product back
to Zoo Med.
Please allow 2-4 weeks for repair or
replacement.
LOOK FOR THESE AND OTHER FINE ZOO MED
PRODUCTS AT A QUALITY PET STORE NEAR YOU!
For a free color catalog of other quality Zoo Med products write to:
Zoo Med Laboratories, Inc.
3100 McMillan Ave
San Luis Obispo, CA 93401 USA
Phone: 1-888-496-6633
e-mail: zoomed@zoomed.com
Check us out on the web:
www.zoomed.com
R
T
EPTI
EMP
500R
REMOTE SENSOR
THERMOSTAT
INSTALLATION
INSTRUCTIONS
ITEM# RT-500R
Introduction
Thank you for buying a Zoo Med
Reptile Product. Zoo Med is a company
run by hobbyists for hobbyists. We
make quality reptile products used by
zoos, veterinarians and reptile
hobbyists throughout the world. Please
read the following directions carefully
and should you have any questions,
feel free to write, phone or e-mail us at
the address listed below.
Description
ReptiTemp
®
500R:
Remote sensor wire
thermostat which will control a
500 watts
maximum of
of reptile
heating devices.
®

Advertisement

loading
Need help?

Need help?

Do you have a question about the REPTITEMP 500R and is the answer not in the manual?

Questions and answers

Summary of Contents for Zoo Med REPTITEMP 500R

  • Page 1 Zoo Med, the thermostat or part has zoos, veterinarians and reptile been subject to accident or improper For a free color catalog of other quality Zoo Med products write to: hobbyists throughout the world. Please usage, including but not limited to: water...
  • Page 2 4. Remote Sensor Probe: Place the end for cleaning. cycle features but cost you $300.00 or Thermostat make sure you have of the 6 ft. sensor wire inside the more!! Zoo Med’s ReptiTemp 500R prior to enough watts of heat to bring your ®...