Table of Contents
Advertisement
Menu Operation
1. DiSEqC Mode
Supports DiSEqC 1.0 and 1.2.
1
.
1
D
i
S
E
q
C
1
.
0
1
.
1
D
i
S
E
q
C
1
.
0
2, 4, or 8 port can be selected for DiSEqC
= =
switch box. You can select and
use the appropriate port for your DiSEqC
switch box.
Use the
buttons to select 2SW,
= =
4SW, or 8SW in the Installation DISEqC
Mode. And then press the
Connect the satellite LNB line to the
= =
appropriate port. To use the port, press the
buttons to set the satellite you want.
Any unused port must be set OFF.
Press the
button or
= =
1
.
2
D
i
S
E
q
C
1
.
2
1
.
2
D
i
S
E
q
C
1
.
2
You can use the DiSEqC 1.2 motorized system,
if it exists.
Setting
Use the
buttons to select the
= =
Motor from the Installation DiSEqC
Mode. And then press the
You can set the Position within the numbers
= =
0 ~ 59 (60). Select the number you want.
Select the name of Satellite.
= =
Select the number of TP which has a good signal from the TP List.
= =
Use the FINE DRIVE, INSTALLER to run the MOTOR.
= =
And then move the antenna to the appropriate satellite.
Press the
button in the Save position to save the set data.
= =
Searching
Use the
buttons to search for the Position and find the name of
= =
satellite you want.
Press the
button in the Go to Position to move to the set position.
= =
Select the channel you want to watch after changing the satellite from the
= =
Channel List. Then, the antenna automatically moves to the set position.
button.
button to save the set data.
button.
20
Advertisement
Table of Contents
Need help?
Do you have a question about the SCI-503 and is the answer not in the manual?
Questions and answers