Ezee Sleeve Overview; Entering The Workstation Chamber Using The Ezee Sleeves - Baker Bugbox Plus UM-017 User Manual

Bugbox Plus

Ezee Sleeve overview

The Ezee Sleeves consists of a sleeve and a cuff. There are 3 sizes of Ezee Sleeve available; small,
medium and large. See section 7.4.2 for ordering details.
The sleeve attaches to the glove port via 2 O-rings. The cuff is then attached to the sleeve via an O-
ring. Note: The workstation should not be used without the Ezee Sleeves attached.

Entering the workstation chamber using the Ezee Sleeves

To enter the workstation via the Ezee Sleeves;

Set the glove port selector switch (Figure 11) to the correct position for the desired hand entry
(Figure 16)

Hold the desired Ezee Sleeve cuff with the opposite hand.

Supporting the Ezee Sleeve cuff, push the desired hand through the cuff of the Ezee Sleeve.
Figure 17 shows this procedure;

Repeat the procedure for the other hand (if both hands are to enter the workstation
chamber).

Press and hold the vacuum pedal with your foot (item 1 in Figure 12) until the internal gas
volume in the sleeves has been evacuated (the sleeves will now be tight around your arms),
then remove your foot from the vacuum pedal.

Repeat the vacuum process to remove oxygen from the Ezee Sleeves.

Unscrew the glove port cover knob by turning it anti-clockwise (counter-clockwise).

Rotate the glove port bar until it is horizontal.
UM-17 R4.0
Figure 17: Entering the cuffs of the Ezee Sleeves
Page 26 of 47 Bugbox Plus User Manual