Replacement Parts And Accessories; Pet Fountain Cleaning - Drinkwell D360-RE Quick Start Manual

Plastic 360 pet fountain

Hide thumbs

Table Of Contents

Table of Contents

17. Align the flow control cap with the raised notches

on the housing cap. Press down and it will snap

into place. Turn the cap to the right to increase the

flow and turn left to decrease.

18. Pick up the fountain by the bowl and place it in a

desired location. Pour water into the bowl. Leave a

½ inch of space between the water level and the

rim of the bowl.

19. Make sure the electrical power cord, the adaptor

and your hands are completely dry. Connect the

in-line plug and make sure no silver is showing,

then plug the adaptor into a standard electrical

wall outlet.

NOTE: Never let the water level fall below 1 in. from the base of the bowl, or your pump might fail.

Pet Fountain Cleaning

NOTE: Replace the carbon filter every two to four weeks and replace the foam filter every one to two months.

1. Unplug the fountain, and disconnect the in-line plug.

2. Pick up the pet fountain by the bowl, and take it to the sink.

3. Disassemble the pet fountain and discard the carbon filter and the foam filter.

4. Reference page 4 for instructions on cleaning your pump. You can use the motor brush from the Drinkwell

Kit to clean inside the pump. Use a solution of 80% water and 20% white vinegar to remove hard water buildup.

5. Wash all other parts with warm water and soap, or place in the top rack of the dishwasher.

6. Reassemble pet fountain.

NOTE: Do not place the adaptor or pump in the dishwasher.