Table of Contents
Advertisement
Quick Links
263 Shoemaker Rd. Pottstown, PA 19464
1-800-345-1178 International: 610-323-2200
Fax: 610-323-6268
www.eastwood.com
®
BR AND
Patent
®
#5,850,976
#6,003,779
Powder Coating System
Part #10198
1999 Best New Product
1998 PA Governor's Award for
Automotive Restoration Market Organization
Environmental Excellence
Instruction Booklet
Instruction Manual Part #10198Q • Rev. 1/06
© Copyright 2006 Easthill Group, Inc.
Advertisement
Table of Contents
Related Manuals for Eastwood HotCoat
Summary of Contents for Eastwood HotCoat
- Page 1 263 Shoemaker Rd. Pottstown, PA 19464 1-800-345-1178 International: 610-323-2200 Fax: 610-323-6268 www.eastwood.com ® BR AND Patent ® #5,850,976 #6,003,779 Powder Coating System Part #10198 1999 Best New Product 1998 PA Governor’s Award for Automotive Restoration Market Organization Environmental Excellence Instruction Booklet Instruction Manual Part #10198Q •...
- Page 2 Contact with the emitter will result in an unpleasant not operate, return the complete unit, freight prepaid, to the Eastwood Company. An R/A # must be shock! To eliminate the shock hazard, touch the emitter to the ground clip after obtained from Customer Service prior to return.
- Page 3 • Make sure you, your work area, and your equipment are dry. Model 10198 HotCoat™ Powder Coating Gun: applies a wide range of • If you are using an extension cord, make sure it is a grounded cord in sound specially formulated powder coatings.
- Page 4 Chemical Rust Removal Once the part is free of paint chemically remove the rust with Eastwood’s OxiSolv Rust Remover pint (#16025) , gallon (#16027), or 20 oz. spray (#16026), and Eastwood OxiSolv Super Gel Gallon (#16028).
- Page 5 5 - 10 psi, with 8 psi being ideal. If you do not have an air compressor, a portable air tank with regulator can be used. The air must be moisture and oil free. CAUTION: Never exceed the 10 psi! For technical assistance e-mail: techelp@eastwood.com To order parts and supplies, call 1-800-345-1178 or www.eastwood.com...
- Page 6 • Inspect part with a high intensity light to make sure you didn’t miss any areas. Touch up as necessary. For technical assistance e-mail: techelp@eastwood.com To order parts and supplies, call 1-800-345-1178 or www.eastwood.com...
- Page 7 To properly cure the HotCoat powders and achieve full chemical, heat (up to 350°F), and chip resistance, along with the smoothest possible finish follow the steps below. Note:...
- Page 8 Note: Gloss Clear (10093) should go into an oven preheated to 350° F and allowed to cure for 20 minutes at 350° F after complete flow out has occurred. Curing at higher temperatures may cause yellowing. For technical assistance e-mail: techelp@eastwood.com To order parts and supplies, call 1-800-345-1178 or www.eastwood.com...
- Page 9 Plastic Media such as our Poly Abrasive Material (#22020) also works well in removing powder coating. Eastwood has a wide selection of abrasive equipment that can use this material. ® VAILABLE...
Need help?
Do you have a question about the HotCoat and is the answer not in the manual?
Questions and answers