Installaing The Water Dispenser Line - Samsung Model RS27KLMR Owner's Manual And Installation

INSTALLING OF THE WATER DISPENSER LINE
For Interior Model
(Case 1)
Connecting to water supply line
- Shut off the main water supply line and turn the Ice maker to
the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker installation kit.
Connect the water line to the refrigerator
- Slip the compression nut and plastic ferrule
through the plastic tube.
- After inserting the sleeve, tighten the compres-
sion nut onto 1/4" compression fitting(union).
Do not overtighten the compression
NOTE nut.
- Slip the compression ferrule and nut on cop-
per (or plastic) tubing as shown.
Tighten the comperssion nut onto the com-
pression fitting(union).
- Turn water on and check for any leakege.
Waterline must be connected to drinkable water only
NOTE
(Case 2)
Check the water supply line
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler "A" to the tap.
- Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the refriger-
ator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
The water line must be connect-
ed to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the puri-
COUPLER "A"
28
1. Cold Water line
2. Pipe Clamp.
3.Copper (or Plastic) line
4.Compression Nut
5.Compression Sleeve
6.Shut Off Valve
7.Packing Nut.
Compression Nut
Ferrule
Sleeve
Compression fitting
Ferrule
Compression Nut
CAUTION
fier to malfunction.
TAP