Mocka Amalfi Cot Assembly Instructions

Mocka Amalfi Cot
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
B
A
screw
long screw
x4
x12
Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters
and power points. Keep all medications, string, elastic, small toys or small items,
such as money, out of reach from any position in the cot.

Assembly

Care must be taken when attaching sides. Do not over-tighten screws as this can
cause damage to the cot.

Care and Maintenance

Regularly check all screws for tightness or damage that could render the cot
unsafe. To clean - use a damp cloth, avoiding the use of detergents or abrasives.

Recommended mattress size

This cot has been manufactured for use with a mattress which measures 1300mm
long x 700mm wide x 100mm in thickness. The width and length are specified
because it is important that gaps between the mattress and the sides and ends
of the cot will not exceed 40mm. This is to minimize the risk of a child's limb
becoming caught in the gap. The thickness of the mattress has been specified to
ensure that the depth of the cot is greater than 500mm with the mattress base in
the lower position to minimize the risk of a child climbing or falling out of the cot.
mocka.co.nz | mocka.com.au
C D
E
bolt nut small screw
x4
x12
Allen key
x1
Side Panel
Cot Mattress Base
WARNING: TO PREVENT FALLS, THE MATTRESS BASE
OF THIS COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP
End Panel
1