Samsung Label Printer; Connecting The Power Supply - Samsung JE68-00131B Operator's Manual

2. Samsung Label Printer

Feed Button
Cover Peel-off
Cover Open/Close
Printer Head
Paper Holder
Paper Guide
Paper(gap) Sensor
Peel-off Sensor
Power Connector
Interface Connectors
(RS-232C, IEEE1284, USB)
Status Indicator
Power Switch
Paper Adjuster
Dip Switch
6

3. Connecting the Power Supply

CAUTIONS:
When connecting or disconnecting the power supply from the printer, make sure that
the power supply is not plugged into an electrical outlet. And the power supply's
rated voltage and your outlet's voltage do not match, contact your dealer for
assistance. Then do not plug in the power cord. Otherwise, you may damage the
power supply or the printer.
1. Make sure that the printer's power switch is turned off, and the power supply's
power cord is unplugged from the electrical outlet.
2. Check the label on the power supply to make sure that the voltage required by the
power supply matches that of your electrical outlet.
3. Plug in the power supply's cable as shown below. Notice that the flat side of the
plug faces down.
7