Pioneer ES Series Operation & Maintenance Manual page 14

3) Cross section drawing number
4) Part number from cross section drawing
5) Description of part
6) Quantity required
7) Package Vehicle Identification Number (VIN)
WARNING!!!
Before attempting to service this pump, read this manual carefully. Operators and maintenance
personnel should have a good understanding of all aspects of this pump and the pumping
conditions. Failure of operating personnel to be familiar with all aspects of pump operation
outlined in this manual could contribute to equipment damage, bodily injury or possible death.
WARNING!!!
Before any servicing:
1) Read this manual carefully.
2) Shut down driver and lock out incoming power to ensure that the pump will remain
inoperative.
3) If the pump or components are hot, allow adequate cooling prior to servicing the unit.
4) Close the suction and discharge valves.
5) Vent the pump slowly and drain completely.
WARNING!!!
If this pump is used to handle any hazardous materials that can cause illness, either directly or
indirectly, take precautions by wearing approved protective clothing and use appropriate safety
equipment.
WARNING!!!
Use lifting and moving equipment in good repair and with adequate capacity to prevent injuries
to personnel or damage to equipment. When lifting the pump with chains or cable wrapped
around the pump, make certain that they are positioned so as not to damage the pump, and so
that the load will be balanced. The bail on trailer or skid mounted units is intended for use in
lifting the pump assembly only. Suction and discharge hoses and piping must be removed from
the pump before lifting.
CAUTION!!!
When servicing this pump, use only components provided by Pioneer Pump, Inc. Any use of
non-authorized parts could result in sub-standard performance, damage to equipment and
possible injury to personnel. Non-authorized parts will also void the warranty.
When using this manual any reference to part numbers or names will be directed to the
applicable cross section drawing. These parts will also be called out in the bill of materials for
full description.
14