Samsung Q1B User Manual page 93

3
On the screen, the password setting buttons are described.
You can set a password by entering numbers between 1 and 4 with the Joystick.
Since the u2 button is used as the Delete (BackSpace) function and the u4 button is used as
the Cancel (Esc) function, enter the password using the Joystick.
Up: 1
Left: 4
Next: 3
Enter a password, press <Enter>, re-enter the password for confirmation, and press <Enter>
again.
4
When a message confirming the password configuration appears in the [Setup Notice] win-
dow, press <Enter>.
The supervisor password has been set. The supervisor password is required to turn the com-
puter on or to enter System Setup.
Setting a User Password
Users can start the system with their user password, but cannot enter the System Setup.
Before configuring a user password, a supervisor password must have been configured. Deactivating
the supervisor password also deactivates the user password.
However, please note that deactivating a user password does not deactivate the supervisor pass-
word.
In the Set User Password item, press <Enter> and complete the procedures of Step 3 for Setting
a Supervisor Password.
Activating the Booting Password
Before activating the booting password, a supervisor password must be configured.
Set the Password on boot option to Enabled. From now on, system booting will not proceed with-
out the password.
Right: 2
Setting a Booting Password 93