Troubleshooting - John Lewis JLDWW1307 User Manual

Troubleshooting

If the appliance does not start or it stops during
operation, before you contact an Authorised
Service Centre, check if you can solve the
problem by yourself with the help of the
information in the table.
Warning! Repairs not
properly done may result in
serious risk to the safety of
the user. Any repairs must be
performed by qualified
personnel.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The end indicator flashes 1 time intermit-
tently.
• The Start indicator flashes continuously.
The appliance does not drain water.
• The end indicator flashes 2 times intermit-
tently.
• The Start indicator flashes continuously.
24
With some problems the end indicator flashes
intermittently indicating a malfunction.
The majority of problems that can occur
can be solved without the need to
contact an Authorised Service Centre.
Possible cause and solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water author-
ity.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
Dishwasher User Manual