Advertisement
i
5
STEP
I.
Place microwave
oven in the opening
of the cut-out.
Be careful nof lo
bend the
Ad-Tip
Flange.
Flange
must be flat to cut-out floor to
engage correctly with Anti-Tip
Bracket as shown.
2.
Plug in microwave
oven.
3.
Center microwave
oven within
the cut-out opening and slide
oven in place.
4.
After oven is in place, ensure
microwave
is accurafely
cenlered.
5.
Drill pilot holes through
Positioning
Flanges and install
Low Profile Screws(P) at the
front of the Ducts as shown.
Anti-TIP
Assembly
Lo
Flanges
7
STEP
1.
Place Trim Frame over the microwave.
Make sure microwave
is centered within
the Frame.
Firmly push Frame against
the wall at the four Spring Clip
locations
as shown.
2.
Check Frame for fig'ghf fit. If Frame
is loose, remove the Frame and make
necessary
adjustments
by loosening
the
Screws, re-positioning
the Clips and
re-tightening
the Screws.
Re-attach
Frame as above.
PART NO. 4313745
6
STEP
1.
Mark center positions (or center punch) for
the pilot holes(4) as shown.
DimA is
measured from the
cut-oul
bottom and
Dim.B is from the cut-out side. The
Q
Top Clip Position
top hole is determined by Dim.C.
Dlm.A = '/,;
Dlm.B = '/; (mln.)
Dlm.C = 16 '/,
Dim. C
2.
Drill pilot holes and install the Spring
1
Clips(4) using Low Profile Strews(4).
_.-.
_-L
Note that the top Clips face up and
the bottom Clips face down as shown.
Dim. A
-+ *Dim.
B
cutout
3.
The Spring Clips are provided with a
Opening
slotted hole for fine adjustments as required.
6
STEP
1.
Your Trim-Kit is now fully
installed.
Replace any loose
items that might have been
removed from the oven.
2.
Please keep this installation
instruction
for future reference.
Page 2
Advertisement
