SILENT KNIGHT 5207 Operator's Manual page 3

Note: Some procedures require you to enter a
code 0 or code 1.
System Testing
The 5207 is active 24 hours a day and
requires very little maintenance. Periodic
testing will ensure that your system is
operational at all times.
Automatic Self Test
The 5207 sends an automatic test to your
security company's central station at a
pre-determined time. You can activate a
manual test at any time. See below.
Manual Test
1. Press the digit
2. Press
ENTER
3. Enter a valid operating code.
The system will perform three tests: a
display lamp test, a bell test, and a
communicator test. Some LEDs that are
normally off will be lit (steady or
flashing) during a system test.
Silencing an Alarm or Trouble
Warning
In some situations, you may want to
silence an alarm or trouble warning. For
example, you may want to silence a
malfunctioning smoke detector that
triggers a fire alarm when there is no fire.
Your security company may prefer that
you silence rather than reset the alarm
until a representative arrives to check
your system. When an alarm is silenced,
the alarm is no longer audible but the
condition that caused it still exists.
.
0
.
Model 5207 Operator's Guide
To silence:
1. Press the
SILENCE
2. Enter a valid operating code.
Resetting an Alarm or Trouble
Warning
When an alarm or trouble warning has
been sounded, your system is not fully
operational until it has been reset.
Resetting should be used when the
condition that caused the alarm or trouble
has been resolved. (See "Silencing an
Alarm or Trouble Warning" to make sure
that you wish to reset rather than silence.)
To reset:
1. Press the digit
Press
2. ENTER .
3. Enter a valid operating code.
Resetting the Dialer
You can abort a fire alarm call to the
central station by resetting the dialer.
To reset the dialer:
Press the digit
1.
2. Press
ENTER
3. Enter access code 0 or 1.
Disabling/Enabling Zones
When a zone is disabled, there is an alert
tone that cannot be silenced until the zone
is enabled. To either enable or disable:
Enter the zone number.
1.
2. Press
DISABLE
3. Enter a valid operating code.
The DISABLE button acts as a toggle.
3
key.
.
1
3 .
.
.