Cleaning The Filters - Shark Navigator LIFT-AWAY Instructions Manual
Nv390 series
Hide thumbs
Also See for Navigator LIFT-AWAY:
- Quick start manual (2 pages) ,
- Quick start manual (2 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Available languages
Available languages
STEP 3
3 Press top dust-cup
release latch to access
dust screen and remove
built-up debris as required.
CLEANING THE FILTERS
1
Pre-Motor
(foam and felt):
With the dust cup
removed, take out and
rinse the foam and felt
filters with water. Tap
loose dirt off filters
between washes
as needed.
FOAM FILTER
FELT FILTER
HEPA
2
Post-Motor (HEPA):
To access the HEPA filter,
reach under the grill and,
pull the tab forward and
pull the grill away from
the vacuum. Remove and
rinse the HEPA filter.
s h a r kc l e a n . c o m
18
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Navigator LIFT-AWAY and is the answer not in the manual?
Questions and answers
how do you clean where the brush is ? does it come apart to clean
To clean the brush area of the Shark Navigator Lift-Away, you can cut tangled hair and debris using a razor blade or scissors and then pull it out with pliers. Focus on the ends of the brush and underneath the rods. The brush roll has grooves and plastic combs to help prevent hair tangling. The vacuum does not easily come apart for cleaning due to special screws, so removing the brush roll may require specific tools.
This answer is automatically generated
is there a suction release button on the shark navigator lift away professional?
it quit sucking up dirt
Your Shark Navigator Lift-Away may have stopped sucking up dirt due to one of the following reasons:
1. Dirty Filters – Clogged filters can reduce suction. Clean or replace them as needed.
2. Full Dust Cup – Empty the dust cup to restore suction.
3. Object Stuck – Check for blockages in the hose, tubes, or roller brush.
4. Hissing Tubes – This may indicate an air leak, reducing suction.
5. Suction Release Valve Misaligned – Ensure the valve is fully closed for maximum suction.
Check these areas and clean or clear any blockages to restore performance.
This answer is automatically generated