KAC WCP1A series Installation Instructions

INSTALLATION INSTRUCTIONS FOR THE WATERPROOF MANUAL CALL POINT MODELS WCP1A....
TO TEST
1
2
3
Important Notes; -
Please do not over tighten fixing screws.
The use of lubricants, cleaning solvents or petroleum based products should be avoided.
The O-ring should be replaced when refitting or replacing the Waterproof Cover.
KAC ALARM COMPANY LIMITED, KAC House, Thornhill Road, Redditch, Worcestershire, England. B98 9ND. T. +44 (0) 1527 406655 F. +44 (0) 1527 406677 E. technical@kac.co.uk W. www.kac.co.uk
TO REPLACE GLASS / RESETTABLE ELEMENT
1
2
3
TO RESET
4
5
6
Installation
The integral back box has three
20mm diameter threaded holes.
Two hole stoppers are provided
for use as required. The cable
entry holes of the back box must
not be subjected to stress by the
cable or conduit. The use of
sealant such as Loctite product
5331 is recommended.
1
Wiring
Connection to the WCP is made
via the 4 way terminal connector
as shown overleaf
Each terminal will accommodate a
conductor of 2.5mm 2 .
Earthing
An Earth Continuity Terminal is
situated in the rear of the back
box. This is designed to
2
accommodate 2 conductors of up
to 2.5mm 2 .
An earthing plate is provided for
continuity of metal conduits. This
must be placed behind the back
box prior to fixing the box to the
wall.
3