Wiring The Electrics; Connections; Remote Control Kit; Programming Remote Control Zappers - Primrose Awnings Full Cassette Instructions Manual

Step 6: Wiring the electrics –

Remote control kit

(THIS STEP APPLIES TO ELECTRIC AWNINGS ONLY)
Our awnings can either be fitted with a plug or wired
into the mains socket. If you choose to wire into the
mains you should consult a qualified electrician. The
following summarises how the wiring works for the
remote control kit and also the indoor wall switch.
If you've purchased a wind, sun and rain sensor kit
please refer to the instructions included with the
sensor and disregard the illustrations on the right.
A. Remote control kit:
Electrical components:
2 x Handheld zappers
1 x Receiver box
1 x 5m electrical wire (3 core) to
connect the receiver box to the mains
1.5m (4ft 11in)
Receiver
of 4 core
box
cable
5m (16ft) of 3
core cable wire
The remote control receiver box should be positioned
indoors or within a waterproof box.
1. Connect the 4 core cable from the awning to the main
receiver box (LREN)
2. Connect the 3 core cable (Mains) to the receiver box
(LNE). The 3 core cable from the remote receiver
box can now be wired into a standard 13 Amp plug
and then plugged in to an existing socket. You can
also wire directly into the mains, complying with
any relevant regulations. If you are unsure of these
regulations, we recommend you consult a qualified
electrician.

Programming remote control zappers:

Normally, the zappers will be preset in the factory. This
will mean that you can simply press the buttons to
activate the awning. If not then perform the following
procedure to program the zappers:
1) Press the button inside the receiver - the green LED
then starts to flash.
2) Press the stop button on the side of the receiver - the
green LED then stays on.
3) Press the Open/Up button on the zapper - setup is
now complete.
Remote Control:
Open
Stop
Lock
Close
Awning
Note:
Receiver box can be placed indoors
or outdoors. If placed outdoors, it will
need waterproof housing. If placed
indoors, the cable from the awning will
need to pass through the wall.
Standard plug socket
(Plug not included)

Connections

Learning Key
Trans
Relay Relay
L R E N L N E
Motor
(Awning)
Motor (Awning) wires:
L= Direction #1
R= Direction #2
E= Earth
N= Neutral
Power Mains:
L= AC Live
N= AC Neutral
E= AC Earth
Open
Stop
Close
Power
Mains
(Brown)
(Black)
(Green & Yellow)
(Blue)
(Brown)
(Blue)
(Green & Yellow)
=