Honeywell V4000 Installation Manual page 2

4
Connect Video Cameras and
Power Supply
1361
XFMR
16.5VAC
POWER SUPPLY
BACKUP
BATTERY 12VDC
_
+
Power Supply
+
12 VDC
DC
_
ADEMCO AD12612 OUT
or Equivalent
AC
IN
+
12 V
DC
NTSC/PAL Video Input
GRN LED (power on)
RED LED (status)
Keybus
NTSC/PAL Video Cameras
Video Input
Connected to
camera via
BNC
Connection
4 x 75 Ω
Termination
Dip Switch
V4000
Telephone
Line
RS 232
DB-9 Male
Connector
5
Connect Telephone Line
Vista
Alarm Control
Panel
Keypad
(ECP)Bus
6
Connect with Central Station
Follow these steps to add video services such as visual verification,
video open/close reports and OzMail notification.
a
Contact your central station account manager (if central station is not
OzVision Compatible, please have them contact OzVision).
b
Inform the central station what services will be used.
c
Provide the central station with the telephone number of the unit, as well
as which sensor is associated with each camera.
d
Provide the central station with the buffer parameters (length of the
pre and post alarm) for the video event.
e
Send signals from each zone to the central station to verify that
signals are being properly received.
4 x 75
+
Termination
12 VDC
NTSC/PAL Video Input
Dip Switch
(BNC Connectors)
V4000
GRN LED (power on)
RED LED (status)
Telephone
Line
Keybus
RS 232
Ring Tip
DB-9 Male
Connector
Handset
RED BLK GRN YEL
Side
Ring Tip
Incoming
Telephone
Line
7
Install the Software
The Control Center Application allows
your customer to dial-in to the V4000 unit
and view live video. Confirm that the
computer meets the minimum hardware
requirements and follow the on-screen
instructions. This software may be installed
on multiple computers by your customer.
Please Note:
A standard modem connection is required
for the computer on which the software is to
be installed.
DSL and Cable modem connections are
currently not supported.
Contact Information
For specific questions and additional information, please contact Honeywell's
Alarmnet Technical Support Group at 1-800-222-6525.
Ω
Telephone
Line
Tip
Ring
Red
Green
(OPTIONAL)
Honeywell's
Control Center
Application
for End Users
CD
V4KQS62505: Rev. 1