Related Manuals for banks Ram-Air
Summary of Contents for banks Ram-Air
- Page 1 Owner’sManual with Installation Instructions Banks Ram-Air ® Super-Scoop ® 2003-2007 Dodge 5.9L Cummins Turbo-Diesel Pickups 2007-2009 Dodge 6.7L Cummins Turbo-Diesel Pickups THIS MANUAL IS FOR USE WITH KITS 42190, 42191...
- Page 2 Banks Monster-Ram 5.9L (P/N 61148-61149) 5.9L (P/N 42765-42766) - 5” touchscreen interface that can Increased flow from intercooler control the Banks Diesel Tuner on - Raises boost without increasing the fly. backpressure at the turbine - Interchangable gauge display, read...
- Page 3 - Achieves a higher peak boost over - Locks Torque Converter and raises stock and gives you precise trans-line pressure boost control that gives you crisp - Works with Banks Exhaust Brake acceleration and more mid-range pulling power Banks Billet Torque Converter 5.9L (P/N 72515) Banks Stinger Systems 5.9L (P/N 49692-49699, 49708-49711,...
-
Page 4: General Installation Practices
Warning: This product is intended replacement. for general highway use. Do not use this product when fording The exploded view of the Ram-Air streams or crossing bodies of Super-Scoop assembly (pages 4-5) water. Although this product provides only general guidance. Refer... - Page 5 Table of Contents Tools Required: • ⁄ ” drive ratchets with metric Section 1 ..... . 6 sockets General Assembly •...
-
Page 6: General Assembly
Section 1 GENERAL ASSEMBLY Figure 1 System # 42190/42191 Shown... -
Page 7: Item Description
Item Description Part # Qty. SUPER-SCOOP, RAM-AIR SYSTEM, DODGE, 5.9L & 6.7L CUMMINS, 42192 STANDARD BUMPER SUPER-SCOOP, RAM-AIR SYSTEM, DODGE, 5.9L CUMMINS, 42193 PAINTED BUMPER (5.9L 03-07) BRACKET, SUPER-SCOOP, STANDARD BUMPER 42194 BRACKET, SUPER-SCOOP, PAINTED BUMPER (5.9L 03-07) 42195 RETAINER, PUSH-TYPE 20mm HEAD X 10mm DIA 92023 RETAINER, PUSH-TYPE, 11 ⁄16 “... - Page 8 If the bottom of Note: For standard bumper vehicles the Banks air housing is sealed, see position the brackets over the larger pages 8-9 of the Banks Ram-Air Intake slot on the Super-Scoop inlet. See Installation Manual. Insert the brackets Figure 3.
- Page 9 Figure 3 Installation of Super-Scoop Support Brackets Figure 4...
- Page 10 Figure 5 Remove Factory nuts Figure 6 Install Super-Scoop support brackets over factory bolts...
- Page 11 ” from Scoop to fit the contour of the lower the bottom edge of the housing. See bumper. Figure 8. Clean the holes and install the supplied clip-on-nuts over the holes. Figure 7 Mark locations of holes on Ram-Air Housing.
- Page 12 Figure 8 Drill marked holes in Ram-Air Housing. Figure 9 Secure Super-Scoop to Ram-Air Housing.
- Page 13 Warning: if the Super-Scoop is For Trucks with Standard Bumpers not positioned properly it will use the holes in front of the Banks interfere with the wheel or Super-Scoop as a template to secure wheel well liner. Make sure there the Super-Scoop to the lower bumper.
Need help?
Do you have a question about the Ram-Air and is the answer not in the manual?
Questions and answers