Solvit Pet Safety Seat Care/Use Manual

Thank you for purchasing the Solvit Pet Safety Seat. Check to make sure the contents include a fabric cover with
tether in polybag; a three-panel plastic main Seat section; and the following plastic sections: Front Strut; Rear Strut;
Right Wall; and Left Wall (name embossed on the side of each).
Assembly: (Make sure the smooth side of each plastic panel faces "in" and the side with round depressions faces
"out"). Insert tab A on Front Strut into slot A in Left Wall and slide Front Strut in the direction of the arrow until tab
A is in the fully locked position.
Repeat this procedure to lock tab B on Front Strut into slot B on Right Wall, and to lock tabs C and D on Rear Strut
into slots C and D on the Left and Right Wall sections.
Place the assembled plastic frame upside-down on a clean surface. The
Outer Fabric Shell has a zipper and small tags marked Z (next to zipper)
and X (on opposite seam). With zipper in the fully open position, slide the
fabric shell over the plastic frame so the Z seam aligns with the H corner at
the back of the plastic frame and the X seam aligns with the G corner.
Pet Safety Seat
™
Care & Use Guide
The main Seat section is a three-panel piece that was
folded in a "Z" shape in the package. Before
connecting to the Left and Right Wall sections, fold
the Seat section into a "U" shape with the smooth
sides facing "in". Insert double-tab E on the front
panel of the Seat section into slot E on the Left Wall
and slide to lock. Repeat for tab G then repeat for
tabs F and H into the corresponding slots on the
Right Wall.
140609