Curbell CSM-BC100 Quick Setup Manual

CSM-BC100 QUICK SETUP GUIDE
Setup
Remove the plastic film from the
1
face of the monitor, and attach the
Velcro strap.
Turn the monitor switch to "ON"
5
Use
TEST THE ALARM: Verify that the alarm is on. Put weight on sensor pad until
1
you hear a double beep and see the green in-use light illuminate. Release
weight to activate alarm.
POSITION THE SENSOR PAD
4
on the chair or bed as instructed/
illustrated on the pad.
Open battery compartment and
2
install the batteries.
INCREASE VOLUME: Increase
6
volume by pressing and holding
the "VOL" button (solid green light
indicates maximum volume).
CONNECTING TO NURSE CALL:
5
Plug a Nurse Call Connection
Cable into the "NURSE CALL"
socket on the monitor, connect
the opposite end of the cable into
the Nurse Call Station (an adaptor
may be required) and test.
NOTE: Consult the "Directions For Use" included with monitor for
complete instructions, troubleshooting, and safety information
Write in the appropriate date(s) on
3
sensor pad.
DECREASE VOLUME: To lower
volume press the "VOL" button,
release, press again and hold
(solid yellow light indicates
minimum volume)
SILENCE THE ALARM: Return
2
weight to the sensor pad or turn
the monitor switch "OFF". Turn
the switch back on to ensure
reactivation.
www.curbellmedical.com • 1-888-222-2188
SENSOR CONNECTION: Wrap
4
the sensor cord around the
strain relief, and then connect to
"SENSOR PAD" receptacle on
monitor.
SECURE THE MONITOR to the
3
back of the patient's chair or bed.
©2015 Curbell Medical Products, Inc. MAP1217B