Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER
APPLICATIONS
Make
Model
Toyota
Hilux (Mexican vehicle)
Toyota
T-100
Toyota
Tacoma
CUSTOM WIRING HARNESS
WIRING LOCATION GUIDE
PICKUP TRUCKS ( T )
Representative vehicle shown below
T1 - Behind driver side taillight housing
T2 - Behind passenger side taillight housing
T3 - Behind driver side rear bumper
T5 - Behind passenger side rear bumper
T1
T3
NOTICE
All steps must be followed to ensure the wiring harness
will function properly. Once installed, test for proper function
by using a test light or connecting a properly wired trailer.
TOOLS NEEDED
10mm socket
Ratchet
WARNING
Exceeding the product rating can cause loss of warranty,
overheating and potential fire. Do not exceed product rating
or tow vehicle lamp load rating, whichever is lower.
Signal Circuits - 3.0 amps per side
Tail / Running Circuits - 7.5 amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
T2
T5
PAGE 1 • 55513-INS-RB
Advertisement
Related Manuals for curt 55513
Summary of Contents for curt 55513
-
Page 1: Installation Instructions
Signal Circuits - 3.0 amps per side Tail / Running Circuits - 7.5 amps total Check vehicle owner's manual or contact the vehicle manufacturer for more information. PAGE 1 • 55513-INS-RB... - Page 2 Route the custom wiring harness end with the green wire to to help prevent corrosion. the passenger side out through the hole between the vehicle bumper and body (D). Repeat step 4 on the passenger side using the harness end with the green wire. 55513-INS-RB • PAGE 2...
Need help?
Do you have a question about the 55513 and is the answer not in the manual?
Questions and answers