Pix-link PL01A Quick Installation Manual

Quick Installation Guide
AV600 Powerline
300Mbps Wi-Fi Repeater
Model-PL01
PL01A:Powerline Adapter
PL01B:WiFi Repeater with Powerline

Quick Setup AP Mode

Internet
1
Connect the powerline adapter to an available LAN port of the
router.
2
Plug in the PL01A and PL01B in the same room. Wait for about
20 seconds until the PL01B's Wi-Fi LED
4
(network name)
Configure the WiFi SSID
a.Connect to the PL01B
For Wired
Disable the Wi-Fi on your computer. Connect your computer to the PL01B via an Ethernet cable.
SYS
AV600
For Windows Users
Disconnect your Ethernet (wired) connection
from your computer.Click the Wi-Fi icon on
the taskbar and connect to the Repeater's
network (e.g. WiFi-Repeater ).
WiFi-Repeater
PL01A
SYS
AV600
Ethernet Cable
3
Pair the powerline devices.
a. Press the Pair button on the PL01A for 1 second. The
SYS LED
Note: If the SYS LED
turns on.
b. Within two minutes, press the Pair button on the
PL01B for 1 second.The SYS LED
When the Powerline LED
process is complete.
and password.
For Mac OS X Users
Disconnect the Ethernet (wired) connection from
your computer (if any). Click the Wi-Fi icon in the
top right corner of the screen, and connect to the
Repeater's network (e.g. WiFi-Repeater
WiFi-Repeater
Wireless-n

LED Explanation

LEDs Name
SYS
SYS LED
LAN LED
PLC LED
WIFI LED

Button Explanation

PAIR/RST: When the button is pressed for 1-2 seconds, the device enters the pairing state.
When the button is pressed for 5-8 seconds, the device releases the pairing state and the
WiFi Repeater restore the factor y settings. When the button is pressed for more than 10
seconds, the Powerlina Adapter restore the factor y settings.
PL01B
Powerline
SYS
AV600
SYS
starts blinking.
SYS
does not blink , press it again.
SYS
starts blinking.
turns solid, the pairing
b. Launch a web browser and type
or http://192.168.10.1
(all lowercase) for both Username and Password, then
click Submit .
http://myrepeater.net
Username
Password
Language
English
d.Change the SSID and Password,Click on "
).
e.After the PL01B reboot has been completed, You can Surf the Internet with the Powerline devices.
Status Indications
Solid The device is on.
Off The device is off.
Blinking
The device is in the pairing procedure.
Solid
The Ethernet port is connected.
The Ethernet port isn't connected.
Off
Device pairing succeeded
Solid
Off The device is not paired or malfunctioning
Off
The wireless function has been disabled.
Blinking
Wireless open
SYS
Blinking
Within 2 minutes
http://myrepeater.net
c.After logging in, you will see the web page
in the address eld. Enter admin
below:
Click on "
Submit
Apply " button, The WiFi Repeater will restart.
SSID SSID of the WiFi Extender
Auto (recommend)
Channel
Setup the wireless security and encryption to
prevent from unauthorized access and
Security type
monitoring. Supports WEP,WPA,WPA2,
WPA/WPA2 encryption methods.
Security Key The "password" of the WiFi Extender
SYS
Blinking
On
AP " to continue.