Advertisement
Shield Removal and Installation
Models
GM49Y
•
FF49
•
FF88
•
GM64
•
GM54
•
OF77
•
GM67
•
Outer Shield lens Removal
1. Raise the outer shield into the fully raised position.
2. Locate the side ratchet plates that secure the shield to the helmet.
3. Push down on the pin that locks the ratchet plate retaining arm into the secure position.
4. As you push down on the pin, move the retaining arm on the ratchet plate on the open
position. The shield will release from the ratchet plate when the retaining arm is in the open
position.
To install the outer shield: reverse the removal process.
Models
GM11
•
Outer Shield lens Removal
1. Remove the two side screws that secure the visor to the helmet.
2. Rotate the lever to release and remove the shield.
3. With the shield in the fully closed position, reinstall the visor and screws.
To install the outer shield: reverse the removal process.
Advertisement
Table of Contents
Related Manuals for Gmax FF49
Summary of Contents for Gmax FF49
- Page 1 Shield Removal and Installation Models GM49Y • FF49 • FF88 • GM64 • GM54 • OF77 • GM67 • Outer Shield lens Removal 1. Raise the outer shield into the fully raised position. 2. Locate the side ratchet plates that secure the shield to the helmet.
- Page 2 Note: Use the same visor screws to secure the shield side plate covers, that are supplied with helmet, when using the less-visor configuration. Models GM44 • MD04 • GM38 • GM69 • GM17 • Outer Shield LENS Removal (Do ONE side at a time) 1.
- Page 3 Models GM64 • Inner Shield lens Removal 1. Lower the inner shield by pushing the slider button located on the left hand side of the helmet completely forward. 2. With the inner shield in the down position, grasp and pull straight out from the helmets eye port on each side of the inner shield to remove.
- Page 4 Models OF77 • Inner Shield lens Removal (Do ONE side at a time) 1. Lower the inner shield lens by pushing the slider (located at the left side of helmet) forward into the fully open position. 2. As the inner shield lens into the fully open position, pull the inner shield lens out straight from the helmet eye port (next to the inner shield lens) first.
- Page 5 completely forward into the “service position”. 2. The service position is achieved by pushing on the rearward part of the slider button and sliding it forward over and past the molded in channel that it rides in. 3. When in the service position, the attachment arm that connect to the inner shield will be visible.
- Page 6 On our website you can discover more about helmets. GMAX puts everything within reach.
Need help?
Do you have a question about the FF49 and is the answer not in the manual?
Questions and answers