Software Installation - Genie Tech Pro Link User Manual

First Edition • Third Printing
Updating the Tech Pro Link
Software
1 Install a USB thumb drive into a
PC or laptop.
2 Launch a web browser on your
PC or laptop. Type in the
following IP address:
http://firmware.genielift.com/
3 Select the Controller Type
drop down menu, select Tech
Pro Link, then select Search.
4 Under Application Firmware,
select the .zip file. Select I
Accept, select Open.
Note: A window will open displaying
a .gff file.
5 Save the .gff file to a USB
thumb drive.
Part No. 1276689GT

Software Installation

6 Remove the USB thumb drive
from the PC or laptop and insert
it into the Tech Pro Link
USB-Type A connection port.
Note: The Tech Pro Link must be
turned off to enter Bootloader Mode.
Press and hold the Power button for
3 seconds.
Press and hold the Left and OK
7
buttons. Press the Power
button until you see Preparing
System Bootloader Mode.
8 Press the up/down arrows to
navigate to the .gff file to be
installed. Press OK to install the
file.
9 After the software has been
updated, remove the USB
thumb drive.
Tech Pro™ Link
User Guide
9