Save Preset, Port Setup & Factory Restore - Nektar Panorama T4 User Manual

Save Preset, Port Setup & Factory Restore
Save Preset
There is always a risk that your current setup is lost, so it's best to save settings regularly.
Here are the steps to save current settings for faders 1-9, LED buttons 1-8 and encoders 1-8:
• Make sure Internal mode is active.
• Press [Setup/Menu].
• Select 'Save' using the [Data/E1] encoder or the arrow up/down display buttons.
• Press [Enter].
• In the top current parameter line it now reads "Save to preset:" Move [Data/E1] to select one of the 10 locations.
• Press [Enter] to save.
Note that this operation will overwrite any other data stored in the selected preset location.
Port Setup
Panorama T4/T6 has several virtual USB ports. They are used to communicate with DAWs via Nektar DAW Integration, however it's also pos-
sible to use them to route control data when using the mode buttons, as long as neither Nektar DAW Integration or Nektarine are active.
• Make sure Internal mode is active.
• Press [Setup/Menu.]
• Select 'Port Setup' using the [Data/E1] encoder or the arrow up/down display buttons.
• Press [Enter].
• In the display window now choose Mixer, Instrument, Multi, Internal or Pad using the arrow up/down display buttons.
• Move [Data/E1] to change the MIDI port routing.
• Press [Save] when done.
You can route any Preset loaded using the Mode buttons (page 15) to the assigned USB port, thereby sending MIDI messages to completely
different destinations at the push of a button. Setting up a unique port for the pads would allow you to separate pad note messages from
keyboard messages.
If Nektarine or Nektar DAW Integration is active, all routing reverts to USB port 1.
Factory Restore
Restoring Panorama T4/T6 to factory settings will result in a reset of all user presets and maps. If you want to preserve your settings, make
sure to backup before executing a factory restore. Go to page 11 for information about how to back up presets and maps.
If you need to restore factory settings (for example if you accidentally managed to change the assignments needed for DAW integration
files), here is how you do that:
• Make sure your Panorama T4/T6 is switched off.
• Press the [Browse]+[View].
• Switch your Panorama T4/T6 on.
• Keep holding the two buttons until the unit has booted up.
www.nektartech.com Nektar Panorama T4 & T6 User Guide 23