Repair Of Wiring Haraness; Connector End Repair Or Replacement; Micro-Pack Connector; Metri-Pack Connectors - Kubota WG1605-E3 Diagnostic Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, DM

REPAIR OF WIRING HARANESS

TWISTED LEADS
1. Locate the damaged wire remove only sufficient
insulation to allow for a complete sealing of the wire
in the connector splice.
2. Place a proper sized heat shrink tube over one of the
cut end and slide back from the splice area.
3. position each of the stripped wire ends into the splice
and ensure there is no bare wire exposed.
4. Solder the connection using a Rosin Core solder
5. Slide the heat shrink tube over the splice and use
heat to shrink the tube over the connection to create
a water tight seal.
6. Re-twist the wire and secure the splice are with
electrical tape to tightly seal the area.

CONNECTOR END REPAIR OR REPLACEMENT

Before making a connector repair, be certain of the
type of connector for example Weather-Pack connectors
and Compact Three connectors look very similar but are
service differently.

MICRO-PACK CONNECTOR

Refer to Figure 2 for the repair procedure for the
repair of a MICRO-PACK connector
Figure 23: MICRO PACK CONNECTOR REPAIR
(1) Connector Housing
(2) Cable
(3) Pin Removal Tool J33095,
BTB234-A

METRI-PACK CONNECTORS

Some electrical connectors on the harness may
utilize a METRI-PACK connector. Refer to Figure 3 for
removal and repair of the terminal.
Figure 24: METRI-PACK Terminal Repair
(1) METRI-PACK Series 150
Female Terminal
(2) Locking Tang
(3) Tool J35689, or Bt-8446
(4) Connector Body
(5) Seal
1-87
ECM SYSTEM
(4) Locking Tang
(5) Terminal
[A] Cut image of connector
[B] End of Wire harness
KiSC issued 12, 2016 A