Controller Operation; Controller Codes - Buyers Products Company SaltDogg 3014199 Installation Instructions

Controller Operation

1. To start spreader, be sure that truck engine is running to prevent battery from discharging. Flip power switch to ON
position. Controller switches will illuminate. Auger and spinner motors will start with full speed for a short time (displays
will show 9) and then drop to the speed settings selected.
2. To adjust speed simply rotate speed knobs until desired speed number is achieved.
3. To activate vibrator flip the Vibrator switch to ON position. Vibrator switch will illuminate. To turn vibrator OFF flip switch
to OFF position.
4. To turn controller OFF, simply flip power switch to OFF position.

Controller Codes

SYSTEM STATUS
POSITIVE WHITE WIRE DISCONNECTED FROM
1
BATTERY,IGNITION WIRE CONNECTED
2 AUGER MOTOR INTERNAL FUSE IS BLOWN
3 SPINNER MOTOR INTERNAL FUSE IS BLOWN
4 VIBRATOR INTERNAL FUSE BLOWN
5 SPINNER MOTOR DISCONNECTED
6 AUGER MOTOR DISCONNECTED
7 SPINNER MOTOR OVERLOADED
8 AUGER MOTOR OVERLOADED
VIBRATOR DISCONNECTED, VIBRATOR EXTERNAL
9
FUSE BLOWN
LOW VOLTAGE (LESS THEN 10 VOLTS FOR 10
10
SECONDS OR MORE)
11
TRUCK BATTERY VOLTAGE FLUCTUATION
12 INSIDE TEMPERATURE OVER 70C (158F)
WIRE HARNESS SHORT, AUGER MOTOR SHORT,
13
SPINNER MOTOR SHORT
14 WIRE HARNESS MOTOR END, OR MOTOR SHORT
Buyers Products Co. warrants all truck/trailer hardware manufactured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts must be properly installed and used under normal conditions.
Any product which has been altered, including modification, misuse, accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of Buyers Products Co. under this warranty is limited to repairing or replacing any part
or parts which are returned, prepaid, and are found to be defective by Buyers Products Co. Authorization from Buyers Products Co. must be obtained
before returning any part. No charges for transportation or labor performed on Buyers' products will be allowed under this warranty.
TM
SPEED SPINNER
DISPLAY DISPLAY
BLINKING BLINKING
F
F
U F
P
A
"SPEED NUM-
BER" BLINKING
REVERSE
CYCLING, THEN
SHOW SPEED
NUMBER
BLINKING
U
L
"L" BLINKING "O" BLINKING
C
H H
"SPEED"
BLINKING
Warranty
2
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
SOLUTION
CONNECT WHITE WIRE TO BATTERY
POSITIVE TERMINAL
REPLACE FUSE, CHECK FOR SHORT
CIRCUIT IN HARNESS, MOTORS
REPLACE FUSE, CHECK FOR SHORT
CIRCUIT IN HARNESS, MOTORS
REPLACE FUSE, CHECK FOR SHORT
CIRCUIT IN HARNESS, VIBRATOR
CONNECT MOTOR, CHECK WIRE
HARNESS, MOTOR CONNECTORS"
CONNECT MOTOR, CHECK WIRE
HARNESS, MOTOR CONNECTORS"
CLEAR OVERLOAD SOURCE
CLEAR OVERLOAD SOURCE
CONNECT VIBRATOR, REPLACE FUSE
TEST TRUCK ELECTRICAL SYSTEM WITH
LOAD TESTER
TEST TRUCK ELECTRICAL SYSTEM WITH
LOAD TESTER
RELOCATE CONTROLLER TO HAVE GOOD
AIR CIRCULATION
REPLACE SHORTED COMPONENTS
INSPECT FOR JAMS. IF NO JAMS FOUND, CHECK
MOTOR HARNESS CONNECTORS FOR SHORT.
3019470 Rev. A