SETTING UP YOUR SLENDERTONE ABS8
Step 1
- Charge the battery.
Insert a suitably approved USB charger into a charging socket
and then connect it to your controller using the USB charging
cable provided (Fig. a). It'll take up to three hours to fully
charge the battery. Your controller is fully charged when you hear
a beep and the battery icon on the display is flashing with all
three bars full.
N
: Do not leave your controller connected to the charger when the battery is fully charged.
OTE
Step 2
– Place the gel pads on the belt.
i) Remove the three adhesive gel pads from their pack. There is a large, square
gel pad and two smaller oval gel pads. One side of each gel pad has a grid
pattern while the other side is black.
ii) Position the belt on a flat surface with the three metal studs facing upwards.
Remove the plastic cover from the grid pattern side of the square gel pad
and place the gel pad grid pattern side down within the blue square to
cover the central metal stud. Press the edges of the gel pad firmly onto the belt.
(iii) Then remove the plastic covers from the grid pattern side of the two oval
gel pads and place them grid pattern side down either side of the square
gel pad (Fig. b) in the positions best suited to your waist size. Press the
edges of both gel pads firmly onto the belt.
: The location of the two smaller gel pads depends on your waist size. In the example below (Fig.c) we
N
OTE
show the smaller gel pads placed farthest from the large, square gel pad. This signifies the position of those
who have a larger waist (36"-42" / 91-107cm). Use the sizing guidelines below to help you choose which is
suitable for you.
I
: Ensure each gel pad is placed grid pattern side down and completely covering the metal studs. Press
MPORTANT
the edges of all three gel pads firmly onto the belt before use.
N
: The gel pads should be replaced every 25-30 sessions.
OTE
4
Fig. c
Fig. a
Fig. b
Need help?
Do you have a question about the Abs8 and is the answer not in the manual?
Questions and answers