MODIFICATION NOTICE. SERVICE MANUAL MODEL E1K E1C PMA-A100 INTEGRATED AMPLIFIER • For purposes of improvement, specif cations and design are subject to change without notice. • Please use this service manual with referring to the operating instructions without fail. • Some illustrations using in this service manual are slightly different from the actual set.
SAFETY PRECAUTIONS The following check should be performed for the continued protection of the customer and service technician. LEAKAGE CURRENT CHECK Before returning the unit to the customer, make sure you make either (1) a leakage current check or (2) a line to chassis resistance check.
WIRE ARRANGEMENT If wire bundles are untied or moved to perform adjustment or parts replacement etc.,be sure to rearrange them neatly as they were originally bundled or placed afterward. Otherwise, incorrect arrangement can be a cause of noise generation. • The photograph is PMA-2010AE. Wire arrangement viewed from the top Front Panel side Back Panel side...
Page 5
Wire arrangement viewed from the bottom Front Panel side Back Panel side...
Page 6
DISASSEMBLY • Disassemble in order of the arrow of the figure of following flow. • In the case of the re-assembling, assemble it in order of the reverse of the following flow. • In the case of the re-assembling, observe "attention of assembling" it. TOP COVER SIDE COVER (L) SIDE COVER (R)
Page 7
About the photos used for descriptions in the “DISASSEMBLY” section. • The direction from which the photographs used herein were photographed is indicated at "Direction of photograph: ***" at the left of the respective photographs. • Refer to the table below for a description of the direction in which the photos were taken. •...
Page 8
(2) Loose the cord holder then remove the screws. Cord holder : Loose (3) Remove the screws, then remove the solder. Solder...
Page 9
2. INPUT UNIT and PH/CD TER.UNIT → → Proceeding : TOP COVER SODE COVER (R) INPUT UNIT and PH/CD TER.UNIT (1) Disconnect the connector wires. CY032 PCB HOLDER CX141 CY031 PH/CD TER.UNIT Direction of photograph: C CX061 CX063 INPUT UNIT (2) Remove the screws INPUT UNIT PH/CD TER.UNIT...
Page 10
3. P.AMP(R) UNIT → Proceeding : TOP COVER P.AMP(R) UNIT (1) Remove the screws. (2) Disconnect the connector wires, then remove the screws. Remove the solder CY056 CX062 Solder...
4. FRONT PANEL ASSY → → Proceeding : TOP COVER SODE COVER (L), (R) FRONT PANEL ASSY (1) Disconnect the connector wire. CX061 Direction of photograph: C (2) Remove the screws. View from bottom (3) Remove the screws. Direction of photograph: B (4) Loose the Cord holders, then disconnect the connector wires.
(5) disconnect the connector wire. CX057 C466 Direction of photograph: B < attention of assembling > Twist the connector wire 5 times and shape it so that it passes under the C466. Please refer to "EXPLODED VIEW" for the disassembly method of each P.W.B included in PANEL FRONT ASSY. 5.
Page 13
6. CE33W==123M → → Proceeding : TOP COVER SODE COVER (L), (R) BOTTOM COVER → CE33W==123M (1) Cut the wire clamp bands. Direction of photograph: D (2) Remove the screws. View from bottom (3) Remove the screws.
IDLING ADJUSTMENT DC Voltmeter Power Trans VR502 VR501 Power Trans 1U-3708-2 1U-3708 -1 Power Amp P.W.B. (R) Power Amp P.W.B. (L) Main Volume IDLING CURRENT Setup 1. Lay the unit at an ordinary position away from a direct current from an air condition or fan. Do the adjustment at a temperature between 15°C (59°F) and 30°C (86°F).
TROUBLE SHOOTING 1. The power can not be turned on. (Power indication LED does not light.) Check the insertion of the 8U-110058-9 AC UNIT. Check the insertion of the 8U-110059 CONTROL UNIT. Check whether power is being supplied to the coil Broken wire in standby trans- Power not supplied.
Page 17
2.4. Power indicator LED is lit normally (green or Check each connector. orange). Check the voltage of each department. Check the operation of the switching relay and speaker relay. Check the Signal line. 3. The power turned on, but a sound does not output normally. (Single channel) Power indicator LED is lit normally (green or Check each connector.
Page 18
SEMICONDUCTORS Only major semiconductors are shown, general semiconductors etc. are omitted to list. The semiconductor which described a detailed drawing in a schematic diagram are omitted to list. 1. IC’s TMP86FS49BFG (IC601) (INT3/TC2) P15 P74(AIN12) /TC5) P16 PDO5/PWM5 P73(AIN11) /TC6) P17 PDO6/PWM6/PPG6 P72(AIN10) (SCL) P50...
Page 19
Terminal name Signal name Function P07(INT2) REMOTE_IN I (INT) Remote control input by codes VAREF VAREF It connects it with the same power supply as VDD of 5pin. AVDD AVDD It connects it with the same power supply as VDD of 5pin. P60(AIN0) RESERVED P61(AIN1)
Page 20
Terminal name Signal name Function RESERVED* RESERVED* RESERVED* RESERVED* RESERVED* RESERVED* * High-current, Sink open drain LB1930M-TLM-E (IC602)
NOTE FOR PARTS LIST Parts for which "nsp" is indicated on this table cannot be supplied. When ordering of part, clearly indicate "1" and "I" (i) to avoid mis-supplying. Ordering part without stating its part number can not be supplied. Part indicated with the mark "★"...
PARTS LIST OF P.W.B. UNIT * Parts for which "nsp" is indicated on this table cannot be supplied. * The parts listed below are for maintenance only, might differ from the parts used in the unit in appearances or dimensions. Note: The symbols in the column "Remarks"...
Page 29
Ref. No. Part No. Part Name Remarks Q'ty New CAPACITORS GROUP C102 CK45E2EAC472MC C102 CONDENSER COVER C103 CE04W1H101MC(RFS#A) C104 CF93A1H104JT (JL) C105 CE04W1V102MC(RA3) C106 CE04W1HR47MT(RA3) C303-310 CQ93M2E101J(LP) E2,E1C C311-321 CE04W1H101MC(RFS#A) C322 CE04W1H221MC(RFS#A) C323,324 CQ93M2E101J(LP) C325 CF93B1H105K(GSG) ) C326 CQ93M2E103J(LP) C701,702 CQ09S2B470KF(PPSC) E2,E1C C703,704...
Page 30
Ref. No. Part No. Part Name Remarks Q'ty New CY042 00D2050355046 4P KR CON BASE(L) CY057 5P EH CONNECTOR BASE CY058 5P KR CON BASE(L) CY061 6P EH CONNECTOR BASE CY063 6P EH CON BASE (RD) F101 00D2061015087 FUSE (4.0A) E2,E1C F101 00D2061046043...
Page 31
8U-110059B uCOM P.W.B. UNIT ASS'Y Ref. No. Part No. Part Name Remarks Q'ty New SEMICONDUCTORS GROUP IC601 8R2431003800D SYSTEM ROM SUB ASSY NOTE : TMP86FS49BFG When update Firmware, please confirm a last version in SDI. IC602 235810039506D LB1930M-TLM-E Use the service board after IC603 00D2631242905 NJM2831F33...
Page 35
Ref. No. Part No. Part Name Remarks Q'ty New CX055 5P EH CONNECTOR BASE CX056 5P EH CON BASE(RD) CX062 6P CONNE.BASE (RED) CX063 6P EH CON BASE (RD) CX064 6P EH CON BASE (BU) CX911-914 M3 SCREW TERMINAL JK301 00D2048548001 4P PIN JACK(18MM) JK306,307...
Page 36
1U-3709E FLAT AMP P.W.B. UNIT ASS'Y Ref. No. Part No. Part Name Remarks Q'ty New SEMICONDUCTORS GROUP TR421-424 00D2730281919 2SC2705 (Y)TPE6 TR425-428 00D2750038045 2SK369 (BL)/(GR)-C TR429-432 00D2730281919 2SC2705 (Y)TPE6 TR433-436 00D2710168900 2SA1145 (O)/(Y)TPE6 TR437,438 00D2750069001 2SK215 TR439,440 00D2750068002 2SJ78 TR451,452 00D2690074907 DTC114TS (10K) T TR453,454...
EXPLODED VIEW Back view WARNING: Parts marked with this symbol have critical characteristics. Use ONLY replacement parts recommended by the manufacturer.
PARTS LIST OF EXPLODED VIEW * Parts for which "nsp" is indicated on this table cannot be supplied. * P.W.B. ASS'Y for which "nsp" is indicated on this table cannot be supplied. When repairing the P.W.B. ASS'Y, check the board parts table and order replacement parts. *...
Page 42
Ref. No. Part No. Part Name Remarks Q'ty New RUBBER PAD SP WASHER SHIELD PLATE P•C•B HOLDER CARD SPACER (L=8) CARD SPACER (L=6) PWB BRACKET (A) BUSH 00D2033996008 AC INLET (2P) BOTTOM COVER 00D1040331107 FOOT ASS'Y TRANS PLATE TRANS PLATE C.PLATE BUTYL SHEET DAMP SHEET(A)
Page 43
Ref. No. Part No. Part Name Remarks Q'ty New SHIELD PLATE ★ 75 FL SPACER ★ 76 SERIAL NO. SHEET ★ 77 INSPECTED LABEL ★ 78 CU PLATE FERRITE CORE ★ 81 BUTYL TAPE(W25 T2) ★ 82 NITOFLON TAPE(W25) ★ 83 CHUKOH TAPE ★...
Page 44
Ref. No. Part No. Part Name Remarks Q'ty New 4P EH-EH CON CORD CN041 ★ 303 5P EH-EH CON.CORD CN054 ★ 304 5P EH-EH CON CORD CN055 ★ 305 5P EH-EH CON CORD CN056 ★ 306 5P EH-EH CON CORD CN057 ★...
PACKING VIEW 208 209 PARTS LIST OF PACKING & ACCESSORIES * Parts for which "nsp" is indicated on this table cannot be supplied. * The parts listed below are for maintenance only, might differ from the parts used in the unit in appearances or dimensions. *...
Page 46
Ref. No. Part No. Part Name Remarks Q'ty New ENVELOPE (ZIPPER A4) 541110578000D INST. MANUAL (E2) 541110579003D INST. MANUAL (E3) 541110580003D INST. MANUAL (E1C) S.S.LIST (EX) WARRANTY (HOME) ENVELOPE 307010059014D RC-1138BK BATTERY(R03X2) ENVELOPE(ZIPPER A5) BRAND BOOK INSPECTION SUB ASSY PMAA100 CONT LABEL SUB ASSY...
NOTE FOR SCHEMATIC DIAGRAM WARNING: Parts marked with this symbol z have critical characteristics. Use ONLY replacement parts recommended by the manufacturer. CAUTION: Before returning the unit to the customer, make sure you make either (1) a leakage current check or (2) a line to chassis resistance check.
Page 49
(E2/E1C) (E3) RR621 OPEN OPEN ZD602 MTZJ12A OPEN MTZJ12A ZD605 MTZJ24A OPEN MTZJ24A TR633 DTC143EK OPEN DTC143EK TR638 DTC323TK OPEN DTC323TK SCHEMATIC DIAGRAMS (1/4) 8U-110059 uCOM UNIT...
Page 50
8U-110058-1 EQ/INPUT UNIT (E2) (E3) 8U-110058-2 S.D SW UNIT R701~R704 OPEN OPEN 8U-110058-3 VOLUME UNIT 470(AMRS) 8U-110058-4 INPUT SEL SW UNIT C303~C310 CQ100p(LP) OPEN OPEN 8U-110058-5 REC OUT SEL SW UNIT OPEN 8U-110058-6 P.DIRECT SW UNIT C323,C324 CQ100p(LP) OPEN 8U-110058-7 DIODE UNIT C701,C702 OPEN...
Page 51
E1C) -60V CN523 8U-210111-1 D101 C507 W915 OPEN SP TERMINAL UNIT L CQ47P(PPSC) +57.7V W352 CX033 TR523 CX015 RL101 OPEN 2SK2967 (PMA-A100) M3_TOP OPEN CN523 CN523 (HOT) -16V R549 390(1W)_AMRA C102 CX022 CY022 OPEN CX013 FF101 OPEN OPEN M3_TOP FH101...
Page 52
PMA2000SE PMA2010AE PMAA100 PMAA100 PMAA100 (E2) (E2/E1C) (E3) C421,422 CQ100P(LP) CQ100P(LP) CQ100P(PPSC) CQ100P(PPSC) CQ100P(PPSC) C437,438 CQ0.01(LP) CQ0.01(LP) OPEN OPEN OPEN C841-844 1000/50(RFS#A) 1000/50(RFS#A) 1000/50(RGO#A) 1000/50(RGO#A) 1000/50(RGO#A) SIGNAL LINE SCHEMATIC DIAGRAMS (4/4) 1U-3709-1 FLAT AMP UNIT 1U-3709-2 POWER SUPPLY UNIT...
Need help?
Do you have a question about the PMA-A100 and is the answer not in the manual?
Questions and answers