After Care; Fitting Instructions - Wickes MONO SINK MIXER Instruction Manual

FITTING INSTRUCTIONS

1. Screw Threaded Stud(8) into Tap Body(1).
2. Fit Body Seating(2) to the Tap Body(1), make sure the
convexity of Body Seating(2) will keep upturned, and then put
diagonal of the Grub Screw into diagonal the hole at the bottom
of Tap Body(1).
3. Check that Anti-Rotational Washer(4) is fitted to Flange(3).
Assemble Flange(3) to Tap Body(1), Screw the Braided
Connector(9) to the Tap Body(1), and then locate the tap
assembly down though hole in the sink.
4. Fit Rubber Horseshoe Washer(5) and Metal Horseshoe
Washer(6) onto Threaded Stud(8). Now fit Fixing Nut(7) onto
Threaded Stud(8). DO NOT OVERTIGHTEN.
5. Bend the Braided Connector(9) to the water supply using
suitable plumbing joints.
6. Turn on the water supply and re-fill the system. Check
immediately for leaks. It is always advisable at this stage to
flush out the system. To do this, open both valves fully and
allow water to flow for approximately 1 minute. This will
remove any foreign matter within the tap body.
7. Finally turn on all the water heating arrangements.

AFTER CARE

Your fitting has a high quality finish and should be treated with care to preserve the visible surfaces.
All surfaces will wear if not cleaned correctly. The only safe way to clean your fitting is to wipe with
a soft damp cloth using clean soapy water. Stains can be removed using a little washing up liquid. Do
not use any other cleaning materials (even non-scratch type) as these will affect the visible surface.
Do not use abrasive cloths or wire cleaners.
If the cloth used to clean the tap has previously been used with a cleaner that contains bleach ,
take special care to thoroughly rinse the cloth with clean water before use.
Wickes Building Supplies LTD
Lodge Way House, Lodge Way
Harlestone Road
Northampton NN5 7UG
Customer service number ：0330 1234 123
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Please note:
Tap heads shown are for illustration
purposes only.
W INST 24 (Rev. 1.2)