Table of Contents
Related Manuals for SnowEx SL-80
Summary of Contents for SnowEx SL-80
- Page 1 This Manual Must Be Read Before Operating The Equipment Owner / Operator’s Manual FOR MODELS SL-80/SL-80SS Customers Copy Madison Heights, Michigan 48071 800-725-8377 www.snowexproducts.com © Trynex International 2011 (REV 001) L1102 5 – 1...
-
Page 2: Table Of Contents
Warranty ........................................12 Side and Bottom View Model # SL-80/SL-80SS ..................................13 Handle Assembly Parts Breakdown Model # SL-80 ..................................14-15 Model # SL-80SS ................................... 16-17 Tank Assembly Parts Breakdown Model # SL-80 ..................................18-19 Model # SL-80SS ................................... 20-21 Pump Assembly Parts Breakdown Model # SL-80 .................................. -
Page 3: General Information
RELIABILITY: High impact linear low density polyethelyne hopper. State-of-the-art electronic dual variable speed control, custom engineered powder coated frame, maximum torque 12-volt motor coupled to a custom engineered transmission; found only on SnowEx products. VERSATILITY: Multi-use capabilities allows spreading of a variety of materials for snow and ice control. -
Page 4: Introduction
Introduction This manual has been designed for your help. It will assist you and instruct you on the proper set-up, installation and use of this spreader. Refer to the table of contents for an outline of this manual. We require that you read and understand the contents of this manual completely (especially all safety information) before attempting any procedure contained herein. -
Page 5: Safety
For your safety warning and information decals have been placed on this product to remind the operator of safety precautions . If anything happens to mark or destroy the decals, please request new ones from SnowEx. Remember, most accidents are preventable and caused by human error. Exercising of care and precautions must be observed to prevent the possibility of injury to operator or others! Never operate equipment when under the infl... -
Page 6: Operational Safety Information
Operational Safety Information Summary of Important Safety Information Chemical accident procedures Immediate response is necessary in the event of sprayer leaks, bodily chemical contact, poisoning, or spills. See instructions below: Sprayer Leak If the sprayer develops a leak, immediately stop spraying. Turn o_ power to the sprayer and follow directions below, as applicable. - Page 7 Operational Safety Information Summary of Important Safety Information LISTED BELOW is a summary of safety information of particular importance. See individual sections of this owner’s manual for more details. DURING ASSEMBLY CHECK and TEST completed assembly as directed in this manual. Serious injury could result from chemical leaks if sprayer is improperly assembled.
- Page 8 Operational Safety Information Summary of Important Safety Information During Spraying • DO NOT OVERAPPLY pesticide. Apply at rate recommended by chemical manufacturer. Excess pesticide can be dangerous to humans/animals, damage desirable plants, and contaminate soil and water sources. • DO NOT EAT, DRINK, SMOKE, RUB YOUR EYES, or TOUCH YOUR BARE SKIN while handling chemicals and spraying. •...
-
Page 9: Operating The Spreader
Sprayer Operation Model # SL-80/SL-80SS 1) Fill sprayer with material through top hole. Caution: Always use gloves and safety goggles when fi lling sprayer. 2) Place valve in position for desired use. 3) If using spray wand never point at objects ie: humans, vehicles etc. -
Page 10: Spreader Maintenance
Sprayer Operation (con’t) & Electrial Schematic Model # SL-80/SL-80SS 1) Charge battery after each use. Disconnect harness and connect to battery charger as shown below. Then plug charger into 110v outlet. F50107 F50106 F50016 F50082 5 – 10 © Trynex International 2011 (REV 001) L1102... -
Page 11: Troubleshooting
Model # SL-80/SL-80SS Whenever service is necessary, your local SnowEx Dealer knows your Sprayer best. Take your Sprayer to your local dealer for any maintenance or service needs on your unit. If this is not possible, the Troubleshooting Guide below may assist you in identifying the problem. -
Page 12: Warranty
Neither Snowex, nor any company affiliated with it, makes any warranties, representations for promise as to the performance or quality other than what is herein contained. The liability of Snowex to the purchaser for damages arising out of the manufacture, sale, delivery, use or resale of this spreader shall be limited to and shall not exceed the costs of repair or replacement of defective parts. -
Page 13: Side And Bottom View Model Sl-80/Sl-80Ss
Side and Bottom Views Model # SL-80/SL-80SS © Trynex International 2011 (REV 001) L1102 5 – 13... -
Page 14: Handle Assembly Parts Breakdown
Handle Assembly Parts Breakdown Model # SL-80 5 – 14 © Trynex International 2011 (REV 001) L1102... -
Page 15: Model # Sl-80
Handle Assembly Parts Breakdown Model # SL-80 © Trynex International 2011 (REV 001) L1102 5 – 15... -
Page 16: Model # Sl-80Ss
Handle Assembly Parts Breakdown Model # SL-80SS 5 – 16 © Trynex International 2011 (REV 001) L1102... -
Page 17: Model # Sl-80Ss
Handle Assembly Parts Breakdown Model # SL-80SS © Trynex International 2011 (REV 001) L1102 5 – 17... -
Page 18: Tank Assembly Parts Breakdown
Tank Assembly Parts Breakdown Model # SL-80 5 – 18 © Trynex International 2011 (REV 001) L1102... -
Page 19: Model # Sl-80
Tank Assembly Parts Breakdown Model # SL-80 © Trynex International 2011 (REV 001) L1102 5 – 19... -
Page 20: Model # Sl-80Ss
Tank Assembly Parts Breakdown Model # SL-80SS 5 – 20 © Trynex International 2011 (REV 001) L1102... - Page 21 Tank Assembly Parts Breakdown Model # SL-80SS © Trynex International 2011 (REV 001) L1102 5 – 21...
-
Page 22: Pump Assembly Parts Breakdown
Pump Assembly Parts Breakdown Model # SL-80 5 – 22 © Trynex International 2011 (REV 001) L1102... -
Page 23: Model # Sl-80
Pump Assembly Parts Breakdown Model # SL-80 © Trynex International 2011 (REV 001) L1102 5 – 23... -
Page 24: Model # Sl-80Ss
Pump Assembly Parts Breakdown Model # SL-80SS 5 – 24 © Trynex International 2011 (REV 001) L1102... -
Page 25: Model # Sl-80Ss
Pump Assembly Parts Breakdown Model # SL-80SS © Trynex International 2011 (REV 001) L1102 5 – 25... -
Page 26: Notes
Notes 5 – 26 © Trynex International 2011 (REV 001) L1102... - Page 27 Notes © Trynex International 2011 (REV 001) L1102 5 – 27...
Need help?
Do you have a question about the SL-80 and is the answer not in the manual?
Questions and answers