Table of Contents
Advertisement
Monthly, test the obstruction and entrapment protection systems.
Monthly, service the gate operator (make sure the power switch is OFF). Clean extended operator arm with a soft, dry clean cloth. After
cleaning, apply a high quality silicon spray to a soft dry cloth and wipe the push/pull tube. DO NOT directly spray the tube!
On all gates weighing 250 lb. or more, routinely grease the ball bearing hinges at least 4 times a year; more frequently if the gates are
near a coastal area.
Monthly, turn off the power switch and disconnect the Mighty Mule and move the gate to make sure the gate is moving freely without
sticking or binding. Lubricate the hinges or repair the gate as required before reattaching the Mighty Mule.
Monthly, check the gate system for potentially entrapments from new landscaping or construction. Eliminate or guard as required.
Monthly, check that the warning signs are mounted on each side of the gate and clearly visible. Replace the signs if they are missing or
damaged.
Replace batteries every 2-3 years and properly recycle old batteries.
If your gate opener does not function properly after it is installed, use this guide before calling the GTO Service Department.
Audible Feedback
Symptom
1 or more short beeps
upon power up
Rapid beeping
1 beep every 20 seconds
off
2 beeps every 2 seconds
1 beep every 2 seconds off
1 beep when attempting to
run the gate
Additional information can be found online 24 hours 7 days a week at the
GTO Tech Wizard (support.gtoinc.com/Support/TroubleShooter.aspx)
MAINTENANCE
TROUBLESHOOTING GUIDE
Diagnosis
Circuit Board Powered
Up & Ready
Circuit Board Senses an
Obstruction
Low Battery Condition
Position sensor is short
circuit.
Position sensor is open
circuit.
Blown fuse
Battery is low or damaged
Loose Connection
Check:
• Normal Operation
• Path of Gate
• Gate for Level and Plumb
• Stall Force Adjustment
• Disconnect Obstruction Detection Devices
• Transformer or Solar Panel Voltage
• Charge the battery if solar conditions have been poor
• Battery Harness Connections
• Battery Under Load
• Arm Power Cable for Damage
• Arm Power Cable for Damage
• Check and replace fuse
• Test battery voltage
• Check all connections
MM260 Installation Instructions
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MM260 and is the answer not in the manual?
Questions and answers
When I turn the MM260 off and back on I get 4 beeps. When I push the button on the remote I get 4 beeps followed by one long beep.