Table of Contents
Advertisement
THIS PRODUCT COMPLIES WITH CAN ICES-2/NMB-2
This chain saw is designed especially for tree service by a trained
operator.
Read the instructions carefully and follow the rules for safe
operation.
Failure to do so could result in serious injury.
ECHO, INCORPORATED
400 Oakwood Road, Lake Zurich, Illinois 60047-1564
Phone : 847-540-8400
OPERATORS MANUAL
WARNING
1
CHAIN SAW
CS-2511T
X7503332501
CS-2511T
8/18
Advertisement
Table of Contents
Related Manuals for Echo CS-2511T
Summary of Contents for Echo CS-2511T
- Page 1 OPERATORS MANUAL CHAIN SAW CS-2511T THIS PRODUCT COMPLIES WITH CAN ICES-2/NMB-2 WARNING This chain saw is designed especially for tree service by a trained operator. Read the instructions carefully and follow the rules for safe operation. Failure to do so could result in serious injury.
- Page 2 For questions regarding terms used in this manual, visit: https://www.echo-usa.com/Support-Help/Technical-Documents https://www.shindaiwa-usa.com/Tech-Support/Technical-Documents WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING Cancer and Reproductive Harm www.P65Warnings.ca.gov Copyright © 2018 All Rights Reserved. CS-2511T...
-
Page 3: Rules For Safe Operation
Don’t let go. on the guide bar when you purchase your ECHO chain saw. 3. Make sure that the area in which you The Kick Guard can be used in a majority of are cutting is free from obstructions. - Page 4 19. Spark arrestor mufflers approved to SAE 6. Do not start cutting until you have a clear Standard J335 are standard on ECHO chain work area, secure footing, and a planned saws to reduce the possibility of forest fires.
-
Page 5: Table Of Contents
The enclosed message provides information CAUTION necessary for the protection of the unit. The safety alert symbol accompanied by the word “CAUTION” calls attention to an act or condition which may lead to minor or moderate personal injury if not avoided. CS-2511T... - Page 6 PARTS” section will help you locate them. Make sure the decal is legible and that you understand and follow the instructions on it. If a decal cannot be read, a new one can be ordered from your ECHO dealer. CS-2511T...
-
Page 7: Packing List
The ECHO product you purchased has been After opening the carton, check for damage. factory pre-assembled for your convenience. Immediately notify your retailer or ECHO dealer of Due to packaging restrictions, guide bar and saw damaged or missing parts. chain installation and other assembly may be Use the packing list to check for missing parts. -
Page 8: Nomenclature Of Parts
NOMENCLATURE OF PARTS OPERATORS * If a decal cannot be read, a new one can be ordered from your ECHO dealer. CS-2511T... - Page 9 11. Saw chain - Chain, serving as a cutting tool. 12. Bar tip guard - Anti-kickback device attached on the bar nose. CS-2511T...
-
Page 10: Operator Safety
If this guideline is not followed, hearing loss can neck, feet and ankles and hands and wrists. occur. • Maintain good blood circulation by performing ECHO recommends wearing hearing protection at vigorous arm exercises during frequent work all times. breaks and also by not smoking. -
Page 11: Correct Use Of Chain Brake
ECHO chain brakes have been designed and tested Reduced radius belongs on top to comply with international safety standards as fol- lows. -
Page 12: Preparation For Use
Never start or operate saw if brake band is not in place on clutch drum. Always check chain brake operation after replacing cover. Do not use saw if chain brake does not function properly. CS-2511T... - Page 13 • In case of being damaged or broken, do not continue using the unit with the lifting hook. Lifting hook • If you have any doubt with regards to their condition, have the unit checked out by your nearest authorized ECHO dealer. CS-2511T...
-
Page 14: Fuel And Lubricant
Diesel or alternative fuels may also in all air-cooled 2-stroke and 2/4-stroke hybrid engines. cause premature deterioration of fuel lines, gaskets, Two Stroke Oil - A two-stroke engine oil, such as ECHO carburetors and other engine components. brand 2-stroke oils, meeting ISO-L-EGD (ISO/CD 13738) and J.A.S.O. - Page 15 30 days, 90 days when a fuel stabilizer is added. Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use. Used oil and gasoline, and soiled towels are hazardous waste materials. Disposal laws vary by locality. CS-2511T...
-
Page 16: Emission Data
• Do not use used or reclaimed oil to avoid various oiler problems. • Use ECHO bar and chain oil. • Use bar and chain oil of the following grades: SAE No. 30....in summer SAE No. 10....in winter or when cutting... -
Page 17: Operation
• Never use fast idle throttle latch for cutting. • Use the fast idle throttle latch only in starting. Choke Choke control knob Starter handle CS-2511T... - Page 18 • Securely hold the chain saw as shown and pull starter handle. • Choke may be used if necessary, but after first firing sound, squeeze and release throttle trigger to release fast idle throttle latch otherwise severe brake damage may occur. CS-2511T...
- Page 19 Throttle trigger NOTICE If engine does not stop, turn choke control knob counterclockwise to stop engine. Return the unit to your authorized ECHO dealer to check and repair ignition switch before starting the engine again. CHECKING CHAIN TENSION • Chain tension should be checked frequently during work and corrected as necessary.
-
Page 20: Cutting Instruction
CUTTING INSTRUCTION GENERAL CAUTION • Read the ECHO “CHAIN SAW SAFETY MANUAL” included with your chain saw for additional cutting and safety instructions. • Wear suitable hearing protection such as earmuffs or earplugs to protect against objectionable or uncomfortable loud noises. - Page 21 5 cm (2 in.) will act as a hinge Second cut when the tree falls, guiding it in the desired direction. One-third tree diameter When the tree starts to fall, kill the engine, place the saw on the ground and make your retreat quickly. CS-2511T...
- Page 22 • The chain saw industry and government agencies have attempted to prescribe various safety devices, but the best protection is to avoid kickback. • Comply with the safety precautions as listed in this Manual and Safety Manual. CS-2511T...
- Page 23 When the brake lever trips, the chain should stop. Immediately release the throttle trigger. WARNING If the chain does not stop immediately, return the saw to your authorized ECHO dealer for Chain brake unlock repair. When the lever is fully pulled toward the operator, brake is unlocked.
- Page 24 (sun mark (sun mark) appears). Spark plug cover NOTICE For operation at normal temperature, return the air shutter to its original position (with the sun mark appears). (5°C, 41°F) It causes over heating of the engine. CS-2511T...
-
Page 25: Chain And Guide Bar Combination
CHAIN AND GUIDE BAR COMBINATION The following combinations are recommended for model CS-2511T. Guide bar Saw chain ECHO Part No. Length mm (in.) Pitch mm (in.) ECHO Part No. Links Double Guard 12A0CD3745 91PXL45CQ 305 (12) 12A4CD3745 90PX45CQ 9.53 (3/8) -
Page 26: Maintenance And Care
MAINTENANCE AND CARE SKILL LEVELS Your ECHO chain saw is designed to provide many hours of trouble free service. Regular scheduled Level 1 = Easy to do. Most required tools come maintenance will help your chain saw achieve that with unit. -
Page 27: Carburetor Adjustment
(ASL) (96.0 kPa). To maintain proper engine Continue adjustment until smooth acceleration operation above 330 m (1100 ft) ASL the carburetor results. may need to be adjusted by an authorized ECHO 7. Check idle speed and reset if necessary as service dealer. described in item 5. - Page 28 • The standard spark gap is 0.6 - 0.7 mm (0.024-0.026 in.). • Correct the spark gap if it is wider or narrower than the standard gap. 0.6 - 0.7 mm (0.024-0.026 in.) • Fastening torque: 10 - 15 Nm (87 to 130 in. lb.). CS-2511T...
- Page 29 • A damaged sprocket will cause premature damage or wear of saw chain. - When the sprocket has worn out 0.5 mm (0.02 in.) or more, replace it. • Check sprocket when you install new chain. Replace it if worn. CS-2511T...
- Page 30 - To increase the delivery volume, turn the adjusting screw counterclockwise. When the screw touches stopper and stops, this position indicates maximum discharge volume. (13 mL/min at 7000 r/min) - Do not turn the adjusting screw beyond the maximum or minimum limit of volume adjustment. CS-2511T...
-
Page 31: Setting The Saw Chain
5/32 in. diameter or 90PX: 4.5 mm diameter) and flat file are used. Keep this angle • To keep correct position and correct angle, use ® the file holder (Sure Sharp 30° Push file as shown 90° Hold the file horizontally CS-2511T... - Page 32 - If the saw chain becomes soiled with resin, for (0.025 in.) instance, clean it with kerosene and soak in it oil. NOTICE Parallel These angles are referred to as Oregon 91PXL or 90PX. To sharpen other follow chain manufacturer’s Depth gauge instruction. CS-2511T...
-
Page 33: Troubleshooting
• Fuel filter clogged • Clean or replace cranks carburetor carburetor • Fuel line clogged • Clean • Carburetor • Ask your ECHO dealer Fuel at No fuel at • Carburetor • Ask your ECHO dealer cylinder cylinder Muffler wet with •... -
Page 34: Storage After Use
Recoil starter Power transmission Automatic centrifugal clutch Fuel Mixture ratio 50:1 ratio with ECHO Power Blend X™ or ECHO Red Armor® ISO-L-EGD (ISO/CD 13738) and JASO M345-FD two-stroke, air-cooled engine oil. Gasoline Use 89 octane unleaded. Do not use fuel containing methyl alcohol, more than 10 % ethyl alcohol or 15 % MTBE. -
Page 35: Warranty Statements
Please go to http://www.echo-usa.com/Warranty/Register-Your-ECHO to register your new product on-line. It’s FAST and EASY! NOTE: your information will never be sold or misused by ECHO, Inc. Registering your purchase enables us to contact you in the unlikely event of a service update or product recall, and verifies your ownership for warranty consideration.If you do not have access to the Internet, you can complete the form below and mail to:... - Page 36 C71915001001 - C71915999999...
Need help?
Do you have a question about the CS-2511T and is the answer not in the manual?
Questions and answers