Table of Contents
Advertisement
Quick Links
2012-2014 Kawasaki EX650R
2012-2014 Kawasaki EX650R
I n s t a l l a t i o n I n s t r u c t i o n s
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
IFC17042.01
www.powercommander.com
2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List
Parts List
1
Power Commander FC
1
USB Cable
1
Installation Guide
2
Dynojet Decals
2
Velcro
1
Alcohol swab
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
YOU CAN ALSO DOWNLOAD THE PCFC
CONTROL CENTER SOFTWARE AND
LATEST MAPS FROM OUR WEB SITE AT:
www.powercommander.com
2012-2014 Kawasaki EX650R - 1
Advertisement
Table of Contents
Related Manuals for Dynojet POWER COMMANDER FC
Summary of Contents for Dynojet POWER COMMANDER FC
- Page 1 Parts List Parts List Power Commander FC USB Cable 2012-2014 Kawasaki EX650R 2012-2014 Kawasaki EX650R Installation Guide Dynojet Decals I n s t a l l a t i o n I n s t r u c t i o n s...
- Page 2 SELECTING THE MAP POSITION The Dynojet Power Commander Fuel Controller (PCFC) comes loaded with up to ten maps. Using a #1 Phillips screwdriver, turn the map select dial to toggle between the loaded maps. Refer to the map position table for the maps included in your PCFC.
- Page 3 FIG.A Remove the seat. Remove the fuel tank. Place the PCFC in the tail section and route the harness towards the front of the bike. Route the PCFC harness under the frame crossover as shown in Figure A. FIG.B Route the PCFC harness under the fuel tank bracket as shown in Figure B. FIG.C Remove the bolts in the air box lid as shown in Figure C.
- Page 4 FIG.D Remove the four bolts securing the air box to the throttle bodies as shown in Figure D. Disconnect the air box temp sensor and hoses leading to the air box. Remove the air box from the bike. FIG.E Unplug the stock wiring harness from the injectors as shown in Figure E. FIG.F Attach the connectors from the PCFC to the stock wiring harness and the fuel injector for both cylinders as shown in Figure F.
- Page 5 FIG.G Locate the Throttle Position Sensor (TPS) on the left hand side of the throttle bodies as shown in Figure G. Unplug the TPS connector from the throttle bodies. Attach the connectors from the PCFC to the stock wiring harness and TPS. FIG.H Attach the ground wire from the PCFC to the negative side of the battery as shown in Figure H.
Need help?
Do you have a question about the POWER COMMANDER FC and is the answer not in the manual?
Questions and answers